Download Print this page

Toro Greensmaster Fixed Head Walk Behind Series Installation Instructions Manual page 8

Groomer drive system

Advertisement

Figure 14
1. Socket-head bolt previously removed from the cover
5.
Press fit the center gear removed previously
onto the hub
(Figure
Important:
Support the inner race of the
gear bearing while pressing it onto the hub.
Figure 15
1. Gear assembly—from the
forward rotation kit
2. Flange-head bolt—from
the forward rotation kit
6.
Install the center gear and hub assembly and
the gear assembly, from the forward rotation kit,
to the cover with 2 flange-head bolts as shown
in
Figure
15.
15).
3. Gear hub—from the
forward rotation kit
4. Center gear assembly
6
Installing the
Groomer-Housing Cover
Parts needed for this procedure:
1
Groomer-housing cover assembly
1
Gasket
5
Flange-head bolt (1/4 x 3/4 inch)
1
Synthetic grease (3.0 oz)
g020882
Procedure
1.
Coat the teeth of the gears with the synthetic
grease supplied with the kit. Use the remaining
grease to fill in the area around the gears.
2.
Place the gasket over the dowel pins on the
groomer housing
g020883
1. Actuator pin in the groove
on the drive gear
2. Clutch assembly
3.
Install the cover onto the groomer housing,
inserting the actuator pin of the clutch assembly
into the groove of the drive gear
4.
Secure the cover with 5 flange-head bolts
(Figure
16) and torque them to 9.6 to 10.5 N∙m
(85 to 95 in-lb).
8
(Figure
16).
Figure 16
3. Flange-head bolt
4. Gasket
(Figure
g020848
16).

Advertisement

loading

This manual is also suitable for:

Greensmaster 04134