C.R. Laurence Pivot-N-View Series Installation Instructions

C.R. LAURENCE CO., INC.
To begin the installation of your new CRL Pivot-N-View Mirror, select the best location either in the bath or
vanity. The mirror may be mounted on a right, left or rear wall. NOTE: It is important that mirror is installed
into wall studs or wood backing.
E
A
• It is recommended that the unit be mounted on a left or right side wall that is within 15" (381 mm)
(Dimension A) from the edge of the mirror over the sink, or on a back wall that is less than 72" (1829 mm)
away.
• When Dimension "A" distance is 15" (381 mm) or less, the mirror should be placed in position "B".
Distance "B" should not be less than 22" (559 mm). 24" to 26" (610 to 660 mm) has been found to be the
best distance for most installations, but a greater distance can be used.
• When the distance to the back wall "C" is not greater than 72" (1829 mm), and if "A" is greater than 15"
(381 mm), mount the unit in position "D" on the rear wall. Be certain that Dimensions "D" and "E" are
equal, or as close as possible. "E" is the dimension from the sidewall to the centerline of the mirror over
the sink.
Tools Needed For Installation:
• Phillips Screwdriver
• 24" Bubble Level
• (2) Wall Brackets (provided by CRL)
• (4) #8 x 1-1/4" Pan Head Phillips Screws (provided by CRL)
crlaurence.com • Toll Free (800) 421-6144 • Fax (800) 262-3299
CALL TOLL FREE FROM ANYWHERE IN THE U.S.A. AND CANADA • ALL PRODUCTS F.O.B. NEAREST WAREHOUSE

Installation Instructions

For Pivot-N-View Mirror
B
C
D