Table of Contents
Advertisement
Method 2
If the lowest down height is required, use two steel angles on each side. Position the 5th wheel
frame directly on top of the tractor frame. Bolt one, angle against the side of the tractor frame
with the short leg down, and the long leg facing outward. Position the second angle on-top of the
first angle with the long leg up, and the short leg facing outward. Weld the second angle to the
5th wheel frame. Bolt the two angles together in several places, and then weld the two angles
together.
Introduction to Operating Controls
th
As a standard, your 5
wheel has been provided with an air shifting hydraulic pump. The control
valve, air lines, and fittings are also included. Also standard is an air control valve. This push
button will prevent the driver from running the PTO while driving, and therefore, result in longer
pump and PTO life.
King Ping Jaw Release
Included with all 5th wheel models is an air valve for the king pin jaw release. Instructions for
installing this valve will be found as part of the installation procedure later in this manual.
Image 1 Console
Power Take-Off
Power Take Off Installation
Install and adjust PTO according to the manufacturer's instructions.
th
Warren Elevating 5
Wheel
Jaw Control
Pump Valve
PTO Valve
12
Advertisement
Table of Contents
