Table of Contents
Advertisement
[Digital Audio]
receiver that is connected through the digital jack
(coaxial/digital).
[Digital Output] - Select a type of digital
output.
[All] - Support multi-channel audio
formats.
[Off] - Disable digital output.
[PCM Only] - Downmix to two-channel
audio format.
[LPCM Output] - Select the LPCM (Linear
Pulse Code Modulation) output sampling rate.
[48kHZ] - For discs recorded at sampling
rate of 48 kHz.
- For discs recorded at sampling
rate of 96 kHz.
Note
[LPCM Output] setting is only available if the [Digital
Output] is set to [PCM Only].
The higher the sampling rate, the better the sound
quality.
[HDMI Audio]
Select the HDMI audio setting when you connect
this product and the TV with an HDMI cable.
[On] - Allow audio output through the TV and
the speaker system. If the audio format on the
disc is not supported, it will be downmixed to
two-channel sound (linear-PCM).
[Off] - Disable the audio output from HDMI
devices connected to this player.
[Audio Sync]
Set the delay time for audio output when you play
a video disc.
1. Press OK.
2. Press
to set the delay time.
3. Press OK
[Volume]
Set the default volume level when you play a disc.
1. Press OK.
2. Press
to set the volume.
3. Press OK
[Sound Mode]
Select a preset sound effect to enhance the audio
output.
[3D] - Select a virtual surround sound effect
that is produced from the left and right audio
channels.
16
EN
[Movie Mode] - Select a sound effect for
movies.
[Music Mode] - Select a sound effect for
music.
[CD Upsampling]
For better sound quality in stereo mode, convert
the music CD to a higher sampling rate.
[Off] - Turn off CD-upsampling.
[88.2kHz] - Convert to twice the original
sampling rate.
- Convert to four times the original
sampling rate.
[Night Mode]
Make loud sound level softer and soft sound level
louder so that you can watch the DVD movies at a
low volume, without disturbing others.
[On] - Enjoy quiet viewing at night.
[Off] - Enjoy surround sound with a full
dynamic range.
Note
Applicable only to Dolby Digital encoded DVDs.
Video setup
1
Press SETUP.
» [General Setup] menu is displayed.
2
Press
to select [Video Setup], and then
press
to enter the submenu.
3
Select an option, and then press OK.
4
Select a setting, and then press OK.
To return to the previous menu, press
BACK.
To exit the menu, press SETUP.
[TV System]
Change this setting if the video does not appear
correctly. By default, this setting matches the most
common setting for TVs in your country.
[PAL] - For a PAL-system TV.
Advertisement
Table of Contents
