Topaz ESC/LED/RW-NYC Installation Instructions

INSTALLATION INSTRUCTIONS FOR
EXIT SIGN AND EMERGENCY LIGHT COMBO UNIT
INSTALLATION INSTRUCTIONS FOR
EXIT SIGN AND EMERGENCY LIGHT COMBO UNIT
EXIT SIGN AND EMERGENCY LIGHT COMBO UNIT
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. Review instruction sheet before beginning installation.
2. All electrical connections must be in accordance with local codes, ordinances, and the National
1. Review instruction sheet before beginning installation.
Electric code.
2. All electrical connections must be in accordance with local codes, ordinances, and the National
3. Disconnect power at fuse or circuit breaker before installing or servicing.
Electric code.
4. Not for outdoor use.
3. Disconnect power at fuse or circuit breaker before installing or servicing.
5. Do not mount in hazardous locations, or near gas or electric heaters.
6. Do not let power cords touch sharp or hot surface.
4. Not for outdoor use.
7. Equipment should be mounted in locations and at heights where it will not be subjected to
5. Do not mount in hazardous locations, or near gas or electric heaters.
tampering by unauthorized personnel.
6. Do not let power cords touch sharp or hot surface.
8. The use of accessory equipment not recommend by the manufacturer may cause an unsafe
7. Equipment should be mounted in locations and at heights where it will not be subjected to
condition.
tampering by unauthorized personnel.
9. Do not use this equipment for other than intended use.
10.All servicing should be performed by a qualified electrician only.
8. The use of accessory equipment not recommend by the manufacturer may cause an unsafe
condition. 11. Allow battery to charge for 24 hours before first use.
9. Do not use this equipment for other than intended use.
10.All servicing should be performed by a qualified electrician only.
SAVE THESE INSTRUCTIONS
11. Allow battery to charge for 24 hours before first use.

MAINTENANCE

SAVE THESE INSTRUCTIONS
Equipment must be tested regularly in accordance with local codes. Replace the batteries as needed according to ambient
conditions. No other maintenance required.

OPERATION

MAINTENANCE
Depress test button. The LED heads will turn on and the LED indicator will turn off. Release test button, LED indicator will
Equipment must be tested regularly in accordance with local codes. Replace the batteries as needed according to ambient turn on and LED heads will turn off.
conditions. No other maintenance required.

TROUBLE SHOOTING GUIDE

If LED heads or LED indicator do not illuminate, check the following:
OPERATION
1. Check AC supply - verify that unit has 24 hours AC supply.
Depress test button. The LED heads will turn on and the LED indicator will turn off. Release test button, LED indicator will
2. Wiring is shorted or battery is not connected.
turn on and LED heads will turn off.
3. Battery discharge. Permit unit to charge for 24 hours then re-test.
4. If above trouble shooting does not solve the issue, contact manufacturer for assistance.
TROUBLE SHOOTING GUIDE
If LED heads or LED indicator do not illuminate, check the following:
1. Check AC supply - verify that unit has 24 hours AC supply.
2. Wiring is shorted or battery is not connected.
3. Battery discharge. Permit unit to charge for 24 hours then re-test.
4. If above trouble shooting does not solve the issue, contact manufacturer for assistance.
www.topaz-usa.com • 925 Waverly Ave • Holtsville, NY 11742 • 800-666-2852 • Fax: 631-758-8026
INSTALLATION INSTRUCTIONS
Items: ESC/LED/RW-NYC

IMPORTANT SAFEGUARDS

IMPORTANT SAFEGUARDS
use Flexible conduit only
use Flexible conduit only
Page 1 of 2
Page 1 of 2