1. Manuals
  2. Brands
  3. Mincey Marble Manufacturing Manuals
  4. Bathroom Fixtures
  5. SD-08
  6. Installation instructions

Mincey Marble Manufacturing SD-08 Installation Instructions

Chrome plated wire corner mount soapdish
Hide thumbs
1
2
3

Advertisement

Table of Contents

Installation Instructions for Mincey Marble Manufacturing's
Chrome Plated Wire Corner Mount Soapdish
Please read the following before attempting to install your new
chrome plated wire corner mount soapdish
These instructions have been written for Mincey Marble's SD-08 chrome plated wire
corner mount soapdish. If you have received a different product than shown, please
contact our office so we can send proper instructions to you.
In preparation, before installing the soapdish, you will need to have completed the
installation of the panel system and sealed the seams of the shower behind where the
soapdish is to be installed with 100% silicone.

Tools and Materials required:

1. Torpedo level
2. Drill with ¼" masonry drill bit
3. 3 plastic wall anchors, stainless screws and mounting brackets (included in each box,
with wire soapdish)
4. 3 ea. clear plastic washers and chrome plated plastic screw caps (packaged separately
and included in your shipment)
5. #2 Phillips head screwdriver
6. Pencil
Product number: SD- 08
Mincey Marble Mfg., Inc.
1940 New Harvest Road
Gainesville, GA 30507
Ph: 800.533.1806
Fx: 770.531.0935
www.minceymarble.com
SD- 08
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SD-08 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Mincey Marble Manufacturing SD-08

  • Page 1 Please read the following before attempting to install your new chrome plated wire corner mount soapdish These instructions have been written for Mincey Marble’s SD-08 chrome plated wire corner mount soapdish. If you have received a different product than shown, please contact our office so we can send proper instructions to you.
  • Page 2 Installing the wire corner soapdish: 1. Determine the height of the soapdish before going any further. It would be best to check blue prints and with the project manager before drilling any holes. Failure to do this could cause unnecessary repair work, which can be time consuming and costly. Also, make sure the soapdish is being installed in the correct corner.
  • Page 3 4. For the longer side of the soapdish, measure back from the corner 6”, along the level line marked on the wall. For the short side, measure two holes, one 3 3/8” and the other 4 7/8” from the corner. Drill these holes with a ¼” masonry bit. 5.

Table of Contents