Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for watersave INSTA-80
Summary of Contents for watersave INSTA-80
- Page 1 INSTA-80 These instructions must be left with the user Installation Guide...
-
Page 2: Table Of Contents
Table of Contents Introduction ............................. 3 Guarantee ............................. 3 Wiring Diagram ............................6 Plumbing Diagram ..........................7 Flow Rate Graph Chart ......................... 8 Pack Contents Checklist ........................9 Specifications ............................9 Installation Requirements ....................... 10 Installation ............................. 10 Commissioning............................. 12 Fault Diagnosis ............................. -
Page 3: Introduction
Having done so, keep it handy for future reference. The Watersave INSTA-80 is an on-demand, no storage, water heater for use with a mains water supply where the pressure is greater than 0.5 bar but less than 4 bar. - Page 4 WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY: 1. Installation of the INSTA-80 must be carried out in accordance with these instructions, and must be conducted by competent personnel. 2. The electrical installation must comply with BS7671 (commonly referred...
- Page 5 21. Always switch off the INSTA-80 at the electrical isolating switch when not in use for long periods. 22. If the INSTA-80 is not to be used for a long period, the water supply to the INSTA-80 must be isolated. If the INSTA-80 or pipe-work is at risk of freezing during this period, they should also be drained of water.
-
Page 6: Wiring Diagram
Wiring Diagram... -
Page 7: Plumbing Diagram
Plumbing Diagram... -
Page 8: Flow Rate Graph Chart
Flow Rate Graph Chart Inlet Water Outlet Water Power Flow Rate Temp. Temp. -
Page 9: Pack Contents Checklist
Pack Contents Checklist INSTA-80 Pre Wired Installation and User Guide Specifications Electrical Nominal Power Rating 240V MCB Protection Device 5.5KW 25Amps Electrical Supply 25 Amp Isolator Switch Cable Entry Point Pre Wired Cable Size 2.5mm² Water Inlet Connection 15mm Flexi Hose Isolation Valve... -
Page 10: Installation Requirements
INSTA-80. This allows the end user to avail of the hot water in their tank during the winter period by isolating the supply from the INSTA-80 and... - Page 11 Allow a flow rate of 2.25 litres per minute on the hottest position if 55°c is the required temperature. The INSTA-80 may be fitted with a sensor tap or push tap. Operate the taps as normal to get the INSTA-80 to heat the water. Electrical installation is as follows: ...
-
Page 12: Commissioning
INSTA-80 Check the power switch to see what power setting the INSTA-80 is set at. The water should now be at your desired temperature. Please see Diagram 1.0 for flow rate to temperature calculations. -
Page 13: Fault Diagnosis
Replace the rubber gasket connection is damaged No display showing No power Ensure power on Display is broken down Contact Watersave Failure of the touch button Touch button or PCB is broken Contact Watersave down Water temperature too high Power setting too high... -
Page 14: Maintenance
Maintenance Cleaning The INSTA-80 should be cleaned using only soapy water and a non-abrasive cloth/sponge. Spare Parts... -
Page 15: Customer Service
Credit or Debit cards The guarantee applies solely to the original installation and we aim to despatch orders within two working days. The INSTA-80 is under normal use and to the original purchaser only. The guaranteed for 2 years from date of purchase.