Siemens RS4755 Installation Instructions

Siemens Energy & Automation, Inc.
Bellefontaine, Ohio 43311 U.S.A.
Installation Instructions
SAFETY INSTRUCTIONS
BREAKER TYPES
FJ6(ETI), F6, HF6, CLF(ETI), HFJ6, SFD6, SHFD6,
(H)(H)FXD6(ETI), (H)(H)FD6, CFD6(ETI), SCFD6,
FFC, FFF
NOTE: This instruction outlines the recommended
installation procedure.
Turn power off supplying device before installing kit.
1. Use 1 1/2" long screws on line and load of all
breaker types listed above except of CLF and
CFD use 2" long screws on load side.
Hazardous voltage.
Will cause death or
severe injury.
Turn power off supplying
device before installing.
Holding Nut
Instructions for Installation of Circuit
Item:
Breaker Rear Connecting Studs for Cat. No.'s
RS4755 and RS4756.
For use with:
Breakers and Molded Case Switches
1 2
Page of
60171A00
Pc. No.
POLE
2
3
Cat. No.
RS4756
1/2 Washer
Cat. No.
RS4756
®
I-T-E F, FD, and FF Frame Circuit
QUANTITY REQUIRED PER BREAKER
4 of RS4755
4 of RS4755 plus 2 of RS4756
Upper End Shield
Install As Shown
See Number 1
Recommended Torque
5-6 Ft. Lbs.
Breaker Base
Lockwasher
5/16 Flat Washer
Line Or Load Terminal
Insulating Bushing
Lower End Shield
(Insert with beveled
end facing breaker
and press into
slots provided at
line & load end of
breaker.)
Panel
Double Face Nuts
Insulating
Tubing
1/2 - 13 Stud
1/2 Washer
Holding Nut
Double Face Nuts
1/2 - 13 Stud
Cat. No.
RS4755