Advertisement
Installation Guidance
1. Install the Battery
* Remove the back cover of the device;
* Connect the cable of the battery and put the battery to its place ;
* Slide the back cover into its place.
Open the back
cover figure
2. Remove the Battery
*
Remove the back cover of the device;
* Hold the battery brace and lift the battery gently;
* Remove the battery.
Remove the battery figure
NEW7210
NEW POS Technology limited
Install the
battery figure
Plug cable figure
Product manual
3
3. Install the SIM/UIM card
* Remove the back cover of device;
* Insert the card into the SIM/UIM card slot .
4. Remove the SIM/UIM card
* Remove the back cover of device;
* Draw the SIM/UIM card out the slot.
Note
Make sure that the device is in power off status when installing or removing SIM/UIM card.
Install
SIM/UIM
card figure
5. Switch the device on
* Press the power key"
", and the LCD backlight is switched on. Hold the power key for more
than two seconds, then the buzzer of device beeps to show device boots successfully and LCD
shows the corresponding program launch menu;
* The device can be powered by battery or AC power supply.
6.
Switch the device off
*
Keep pressing the power key"
"for more than two seconds. The device will beeps and
the LCD backlight will be switch off.
7. Loading thermal Paper roll
* Pull the handle on the paper holder lid to open the lid up;
* Load the paper roll into the paper holder and extend the paper for 2-3 cm above paper cutter ;
* Close the paper holder lid;
* Please take out the paper shaft and replace the print paper timely when it runs out.
NEW7210
NEW POS Technology limited
Product manual
4
Advertisement
