Summary of Contents for K&K Sound Systems Meridian PRO
Page 1
541-888-4846 dieter@kksound.com www.kksound.com Installation Instructions Meridian Meridian Meridian Meridian PRO Acoustic Guitar Microphone System Acoustic Guitar Microphone System Acoustic Guitar Microphone System Acoustic Guitar Microphone System First time Installation Separate the 2 clamp parts. They are held together by Velcro. Bend the bottom part to fit the exact shape (angle) of the guitar body.
Tightly press the 2 clamp parts towards each other while snapping the Velcro together. If done properly the non-slip-padding will now hold the clamp and mic securely to the instrument. If necessary you can further tighten the clamp by following the instructions below. For a start, position the mic as shown.
Page 3
If several phantom power consumers are connected to a mixing board, the power may drop down below a sufficient supply voltage for the Meridian Pro Preamp. The battery will be activated only in case the phantom power gets too low but it will not be...
Page 4
To set the gain correctly, you have to mount and connect your mic to the guitar and plug it into the Meridian Pro Preamp. Connect it to your amplification system and set the channel to a low volume setting for a start.
Page 5
Round and warm tone is only achieved when acoustic and amplified sound oscillate in the same phase. The Meridian Pro Preamp’s phase switch allows for instant correction of this problem. Play your instrument and flip the phase switch back and forth. You will experience a fuller and warmer tone one way or the other.