Martha Stewart Living TV70M3ACDL05 Manual

Safety Information

IMPORTANT SAFETY
INSTRUCTIONS
When using electrical products, basic precautions should always
be followed, including the following:
READ AND FOLLOW ALL
a.
SAFETY INSTRUCTIONS.
b. Do not use seasonal products outdoors unless marked
suitable for indoor and outdoor use. When products are
used in outdoor applications, connect the product to a
Ground Fault Circuit Interrupting (GFCI) outlet. If one is
not provided, contact a qualified electrician for proper
installation.
c. This seasonal product is not intended for permanent
installation or use.
d. Do not mount or place the product near gas or electric
heaters, fireplaces, candles, or other similar sources of
heat.
e. Do not secure the wiring of the product with staples or
nails, or place on sharp hooks or nails.
f. Do not let lamps rest on the supply cord or on any wire.
g. Unplug the product when leaving the house, when
retiring for the night, or if left unattended.
h. This is an electric product and not a toy! To avoid risk of
fire, burns, personal injury and electric shock it should not
be played with or placed where small children can reach it.
i. Do not use this product for other than its intended use.
j. Do not hang ornaments or other objects from cord, wire,
or light string.
k. Do not close doors or windows on the product or exten
sions cords as this may damage the wire insulation.
l. Do not cover the product with cloth, paper, or any materi
al that is not a part of the product when in use.
m. This product is equipped with push-in type lamps. Do not
twist lamps.
n. Read and follow all instructions that are on the product
or provide with the product.
SAVE THESE INSTRUCTIONS
o.

USER SERVICING INSTRUCTIONS

LAMP REPLACEMENT

Step 1. Grasp the power adaptor or power cord plug, and than
unplug from the power outlet. Do not pull the power cord.
Step 2. Lift up lamp lock tab, then pull the
lamp and plastic lamp base straight
out of the lamp-holder.
Step 3. Replace with a new spare lamp
provided with this product.
( Reference figure only)

Pre-Assembly

Package Contents

Part Description
A Tree top
Tree center, Tag 2
B
Tree center, Tag 1
C
D Tree pot

Assembly

Assembling the tree stand

. Choose a location near a wall outlet.
Step 1
. Unfold the legs of the tree stand and lay the stand
Step 2
on the floor.
. Slide the locking disk of the tree stand down until it
Step 3
snaps into place.

Assembling the tree

. Remove the protective caps from the tree bottom
Step 1
and insert the pole into the tree stand.
. Continue by inserting the upper tree section(s) to
Step 2
the lower section(s) until inserting the tree top.
. Shape the branches to your preference by working
Step 3
from the bottom to the top. When adjusting branches,
ensure that all wires are free of branch hinges.
. Insert the adaptor into the wall outlet. All your lights
Step 4
should now be lit.
Step 5. Shape the tree from the bottom to the top. Start with the
branches farthest from the pole – fan out in a star shape,
and continue until the entire tree is shaped.
Top view
. When finished shaping the branches, slightly
Step 6
upsweep all branch tips for a uniform look.
Tree top
Section 2
Section 1
Christmas Tree
Model# TV70M3ACDL05
Sku # 1003 143 270
Quantity
1
1
1
1
Side view
Adaptor
To Be Plugged
Into Wall
Outlet