Philips HTR5205/98 User Manual page 17

To adjust the audio delay for the
rear speaker
Press . or > until 'REAR DELAY'
appears.
Press PROGRAM on the front panel.
Rotate the VOL control to change the
delay time. Select from : 15ms, 12ms,
9ms, 6ms, 3ms or OFF (default setting).
To remain with the previous setting, do
not rotate the VOL control in the next
fi ve seconds.
C
To confi rm your settings, press
PROGRAM on the front panel.
D
To exit from the setup menu, press .
or > to select 'EXIT'.
Helpful Hints:
– Use longer delay time settings when the
rear speakers are closer to the listener than
the front speakers.
– In DISC 6CH and RADIO mode, the
SETUP MENU is not available.
– In STEREO mode, when CENTER DELAY,
REAR DELAY or TEST TONE is selected, the
display panel will show "UNAVAILABLE FOR
STEREO MODE.". Press SURROUND button
to select another surround mode.
– AUTO PROGRAM is only available RADIO
mode only.
1_htr5205-98_EN.indd 17 1_htr5205-98_EN.indd 17
Getting Started
Adjust the speaker trim level
(Only available in DOLBY DIGITAL, DTS, PRO
LOGIC, MOVIE, MUSIC modes)
You can adjust the speakers trim level
within the range of –10dB to +10dB. The
default setting is 0dB.
A
Press and hold PROGRAM on the front
panel for fi ve seconds to access the
system setup.
B
Press . or > until 'TEST TONE'
appears.
C
Press PROGRAM on the front panel.
Each speaker will be tested
automatically.
Sound will output from each speaker
for two seconds. To adjust the trim level,
rotate the VOL control.
D
Once complete, press PROGRAM on
the front panel.
E
To exit from the setup menu, press .
or > to select 'EXIT'.
Helpful Hint:
– To remain with the previous setting, do not
rotate the VOL control whilst the individual
speaker is tested. After two seconds, the next
speaker will be tested, adjust the VOL control
if necessary.
Adjust the speaker output levels
(Not available in STEREO mode)
You can adjust the rear speakers, centre
speaker and subwoofer output levels by
comparing the sound from the front
speakers.
A
In 'DISC 6CH' mode, press SPEAKER
SELECT button on the remote control
to view each individual channel trim
value.
B
To adjust its level, press the VOL+-
buttons on the remote control.
(continued)
17
2007-03-30 11:53:52 AM 2007-03-30 11:53:52 AM