Advertisement
Quick Links
Coolant Chiller Installation Instructions
Introduction
This procedure will show you how to install the Coolant Chiller option on a VF machine.
Machine Compatibility
• Next Generation Control
• 100.19.000.1000 Software Version
For instructions on how to operate the coolant chiller refer to:
Coolant Chiller - Installation
Revision 1
AD0468
COOLANT CHILLER -
Page 1 of 11 pages
LAST UPDATED: 02/07/2020
OPERATION.
Advertisement
Summary of Contents for Haas Automation Coolant Chiller AD0468
- Page 1 Coolant Chiller Installation Instructions LAST UPDATED: 02/07/2020 Coolant Chiller - Installation Revision 1 AD0468 Introduction This procedure will show you how to install the Coolant Chiller option on a VF machine. Machine Compatibility • Next Generation Control • 100.19.000.1000 Software Version For instructions on how to operate the coolant chiller refer to: COOLANT CHILLER - OPERATION.
- Page 2 Coolant Chiller Installation Instructions Coolant Filter - Removal Remove the machine screws [1] that attach the coolant filter to the enclosure panel. Hold the coolant filter over the coolant tank and remove the drain plug [2]. Allow the coolant to drain from the filter.
- Page 3 Coolant Chiller Installation Instructions Coolant Chiller - Installation Page 3 of 11 pages...
- Page 4 Coolant Chiller Installation Instructions Small VF Secure the drill template to the enclosure in the location specified by the diagram. X= 24" (61 cm) Y= 53" (135 cm) Note: There were a few VF-2YT that had a stiffener on back panel. These models will require a spacer and longer bolts that are included in the kit.
- Page 5 Coolant Chiller Installation Instructions Align the upper bracket [1] with the upper three holes drilled in the enclosure panel using the template. Raise the left side window and install the coolant chiller upper bracket [1] onto the enclosure panel using the sealing washers [2] and machine screws ...
- Page 6 Coolant Chiller Installation Instructions Install the nylon washers [1] over the heat exchanger fittings. Install the 90 degree fittings [2] onto the heat exchanger fittings. Install the wing tip hose barb fittings [3] onto the 90 degree fittings [2]. Page 6 of 11 pages...
- Page 7 Coolant Chiller Installation Instructions Coolant Filter - Installation Install the machine screws [1] into the coolant chiller so that about 1/2 of the threads are engaged. Slide the coolant filter assembly [2] onto the machine screws [1]. Tighten the machine screws [1]. Install hose caps onto all the barb fittings.
-
Page 8: Electrical Installation
Coolant Chiller Installation Instructions Electrical - Installation Page 8 of 11 pages... - Page 9 Coolant Chiller Installation Instructions Power down the machine and set the main circuit breaker to [OFF]. Page 9 of 11 pages...
- Page 10 Coolant Chiller Installation Instructions Small VF (not shown): Remove the enclosure panel located below the control cabinet. Route the temperature sensor cable and coolant chiller power cable to the hole in the bottom of the control cabinet. Note: Follow the existing coolant cables routing.
-
Page 11: Operation
Coolant Chiller Installation Instructions Install the cabcool / coolant chiller power supply [1] onto the main transformer using the machine screws [2], lock washers [3]. and washers [4]. Remove the sheet metal cover [1] from the main transformer. Remove the red, white, and black power cables from the terminal block .