/ sauna being on. Menu settings indicator light. This light comes on when a menu setting is adjusted. (timer, the time the device is on, the target temperature of the sauna stove) Three-digit display Starsauna Oy Technical Support: Pistotie 4 +358405455625 (from 8-16) 15860 Hollola, Finland info@magnumkiuas.fi...
2. When the sauna temperature is on the display, pressing the (+/˄) or (–/˅) button causes the controller to move directly to the target temperature settings. Exiting the menu happens as described in section 1. Starsauna Oy Technical Support: Pistotie 4...
The timer’s setting nevertheless remains in the device memory. When the device is on, the default mode (temperature) and the remaining time alternate on the display. The alternation interval is approx. 10 seconds. Starsauna Oy Technical Support: Pistotie 4 +358405455625 (from 8-16) 15860 Hollola, Finland info@magnumkiuas.fi...
Mn: <0.05 mg/l substances are manganese Ca: <100 mg/l (Mn) and chalk or calcium (Ca) Water containing chloride Health risk Use is banned Seawater Fast corrosion Use is banned Starsauna Oy Technical Support: Pistotie 4 +358405455625 (from 8-16) 15860 Hollola, Finland info@magnumkiuas.fi...
6.6 KW 3x10 A 5x1.5 mm 5-9 m Magnum 9 9 KW 3x16 A 5x2.5 mm 8-15 m Magnum 10.5 10.5 KW 3x16 A 5x2.5 mm 10-20 m Starsauna Oy Technical Support: Pistotie 4 +358405455625 (from 8-16) 15860 Hollola, Finland info@magnumkiuas.fi...
1.Blue 2.White 3. Red 4. Yellow PLEASE NOTE! If the wire needs to be shortened, shorten it from the stove’s side. The wire must not be continued. Starsauna Oy Technical Support: Pistotie 4 +358405455625 (from 8-16) 15860 Hollola, Finland info@magnumkiuas.fi...
Page 10
1704106). The lights connector is located in the middle left. The maximum strength of lamps is 100W/0.5A • P – External – Brown above • N – 230VAC – Blue below Starsauna Oy Technical Support: Pistotie 4 +358405455625 (from 8-16) 15860 Hollola, Finland...
Page 11
There may be impurities in the stones, and some residue of storage/machining lubricants on the sauna stove, the traces of which will disappear during the first heating. Also monitor the settling of the stones after the first heating, and add more stones on top, if necessary. Starsauna Oy Technical Support: Pistotie 4...
Do NOT cut the wire from the thermostat’s side. The thermostat sensor does not function if the wires are continued/reconnected. If the wire needs to be shortened, shorten it from the connector’s side. In other cases, contact the technical support. Starsauna Oy Technical Support: Pistotie 4...
Place the frame on the bottom of the box, connect the wires to the panel, and press the control panel to fasten it in the middle of the frame. The panel will be attached to the bracket with magnets. Wiring instructions on page 11. Starsauna Oy Technical Support:...
The panel will be attached to the bracket with magnets. Wiring instructions on page 11. The panel can be integrated into the light switches using a double frame. Any frame from the Schneider Electric Exxact range can be used. Starsauna Oy Technical Support: Pistotie 4...
B. The distance of the thermostat from the ceiling is 100 mm. C. The minimum distance of the control panel from the sauna stove is 500 mm. D. The maximum height of the control panel from the floor is 1000 mm. Starsauna Oy Technical Support: Pistotie 4...
It is recommended that incoming air is directed straight on top of the sauna stove, so that fresh air can be distributed in the steam room with the steam. Air should be replaced six times per hours. A- Supply air B- Exhaust air Starsauna Oy Technical Support: Pistotie 4 +358405455625 (from 8-16) 15860 Hollola, Finland info@magnumkiuas.fi...
The valve is opened after a sauna session, to let the sauna dry. Air can partially escape also to the washroom, if there is a sufficiently large gap underneath the door. A- Supply air B- Exhaust air Starsauna Oy Technical Support: Pistotie 4 +358405455625 (from 8-16) 15860 Hollola, Finland info@magnumkiuas.fi...
If necessary, install the sauna stove’s wall brackets in accordance with SECTION 4.5. Finish piling stones in the sauna stove. The stones on the top should be tightly packed. You should put large stones on top. Starsauna Oy Technical Support:...
Page 19
3 mths. The use of ceramic stones other than (KERKES) is forbidden. Other ceramic stones may cause the resistors to break down prematurely. Starsauna Oy Technical Support:...
Place the brackets to the hollows of the upper part of the sauna stove, according to the image, and screw the brackets to the wall Finish piling stones in the sauna stove. The brackets will be covered by the stones. Starsauna Oy Technical Support:...
800mm 500mm Reducing safety distances: • 50% using single protection (1mm metal/fibreboard and 30mm air gap) • 75% using double protection (double protective covering and air gap) Starsauna Oy Technical Support: Pistotie 4 +358405455625 (from 8-16) 15860 Hollola, Finland info@magnumkiuas.fi...
Starsauna Oy guarantees the quality and functionality of the sauna stoves during the warranty period. The warranty requires that the manufacturer’s instructions are followed carefully. The warranty does not cover faults caused by incorrect installation and/or incorrect use.
We recommend keeping the receipts for any purchased stones etc. Maintenance history. Date Work done Starsauna Oy Technical Support: Pistotie 4 +358405455625 (from 8-16) 15860 Hollola, Finland...
The sauna stove does not heat Remove the stones and check the condition of the resistors. If the properly resistors are in working condition, contact technical support. Starsauna Oy Technical Support: Pistotie 4 +358405455625 (from 8-16) 15860 Hollola, Finland...
Page 28
Copyright Starsauna Oy – We reserve the right to make changes Starsauna OY Pistotie 4 15860 Hollola, Finland info@magnumkiuas.fi www.tahtisaunat.fi...
Need help?
Do you have a question about the Magnum Original 6,6kW and is the answer not in the manual?
Questions and answers