Advertisement
Assembly Instructions
Estimated Assembly Time: 20 minutes
1. Remove the filter assembly from the package and untie
the power cord.
2. Place the filter on a level surface.
3. Press the handle and turn it until it is in between the
"CLEAN" and "WORK" position.
4. Use a Phillips screwdriver to remove the four (4) screws
around the handle and the one screw at the back of top
cover. Lift cover straight up to remove it from the filter
head.
5. Twist the UV cap counterclockwise and pull the UV lamp
socket out.
6. Insert the UV bulb to the UV lamp socket and re-
assemble the UV lamp socket and top cover in reverse
order.
7. Once the top cover is secure, press and turn the handle
to the "WORK" position.
8. Connect one end of a length of 3/4 in. tubing (not
included) to the nozzle marked "IN", and the other end to
the pump (not included). (Fig.1)
9. Connect another length of tubing to the nozzle marked
"OUT". Attach the other end of the tubing to a spitter,
waterfall, fountain or other water feature of your choice,
directing the flow of water back into the pond. (Fig.1)
10. The filter is not designed to be submerged. Place the
filter in a clean, dry area.
11. Connect the lamp power cord to the power source.
13. To operate the pressurized filter, the handle should be in
the "WORK" position (Fig.2).
14. To clean the pressure bucket, press and turn the handle
to the "CLEAN" position (Fig. 2).
15. To optimize the UV clarifier performance, the ideal flow
rate of the pump should be 792 gph or less with a
minimum of 20 gph.
Important Note:
This product is designed to prohibit operation unless it is
fully assembled with the UV lamp base screwed completely
into the lamp housing. UV rays are harmful to your eyes and
skin. Do not attempt to operate this product unless the UV
lamp is completely assembled within the lamp housing.
Self Cleaning Function
The pressurized filter is equi
pped with a specially developed backwash
cleaning system and does not need to be disassembled to be cleaned.
1.
Turn the power off to the pump connected to your pressurized filter.
2.
Disconnect your water feature tube attached to the "OUT" nozzle and
3.
Move the handle from "WORK"' to "CLEAN" and switch your pump on.
4.
The water flow is now reversed through the filter media.
5.
The solids are expelled from the pressure filter via the UV
expelled and clear water is discharged from filter.
attach a separate waste tube leading to your waste water collection.
chamber and waste connection. Continue the cleaning process until all the dirt soilds are
2
Advertisement
