Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Blatchford Kato Plus
- Page 1 KATO Plus Instructions for Use blatchford.co.uk...
- Page 2 938407/2-0917...
-
Page 3: Table Of Contents
KATO Plus Instructions for Use Contents Introduction Safety Information Pre-use Checks Installing the Kato Plus on a Wheelbase Adjusting the Head Support Thoracic Supports and Hip Supports Installing the Medial Thigh Support (Pommel) or the Anterior Knee Supports (Knee Blocks) -
Page 4: Introduction
The Kato Plus should be installed and adjusted only by a qualified clinician or seating engineer. Do not attempt to install the Kato Plus in any wheelbase other than the one installed in the clinic. Before using the Kato Plus, check that all secondary support devices are secure and function correctly. -
Page 5: Pre-Use Checks
Instead, always use a separate passenger restraint system that is attached to the motor vehicle. If the Kato Plus is installed in a wheelbase with a reclining back support, the back support should be in an upright position during travel. -
Page 6: Installing The Kato Plus On A Wheelbase
5. Tighten both retaining straps by pulling the loose end of the webbing away from the buckle. fig. 6. If the Kato Plus has a tube on the rear of the back support (fig. 2) make sure that the U-shaped brackets (A) fasten around the push handles of the wheelbase (B). - Page 7 1. Undo or disconnect the back support fixings. 2. Firmly pull the D-ring (fig. 8), which is located under the front of the seat, then lean the Kato Plus forward. 3. Lift the Kato Plus upward and clear from the wheelbase. fig. 938407/2-0917...
- Page 8 AEL mounting kit Components: L-Bracket G J-Hook VERSAlock® Securing Clip These components should not be adjusted in any way by either the user or the carer. Components F and G screw together with the supplied fittings and attach to either the back of the back support (fig.9) or the bottom of the seat base (fig.13).
-
Page 9: Adjusting The Head Support
3. Re-tighten the locking knob. To adjust the angle of the head support (K), contact the wheelchair service provider. The head support must be in place when travelling in the Kato Plus. See page 12 for more information. Thoracic Supports and Hip Supports Thoracic support adjustments The thoracic supports are positioned to suit the postural needs of the user. -
Page 10: Installing The Medial Thigh Support (Pommel) Or The Anterior Knee Supports (Knee Blocks)
Installing the Medial Thigh Support (Pommel) or the Anterior Knee Supports (Knee Blocks) Slide the end of the square tube into the bracket • until it will not go any further (fig. 16). Knee blocks should not contact the user’s knee caps. Hold the support and push the •... -
Page 11: Adjusting The Foot Support
The instructions for use for the posture belt and posture harness contain important safety information. If you do not have this document, please contact Blatchford. Always refer to the instructions for use (938408) before installing a posture belt or posture harness. -
Page 12: Adjusting The Moulded Tray
Adjusting the Moulded Tray Moulded trays provide both a work and play surface with support and control for any seating arrangement. To adjust the distance between the tray and the user: 1. Make sure that the two vertical stems that are on the underside of the tray are securely located in the wheelbase location points. -
Page 13: Travelling In A Motor Vehicle
Safety information Use the Kato Plus only with a wheelbase that has been tested as part of a wheelchair system that conforms to ISO 7176-19 performance requirements, and that has securement points for use with four-point, strap-type tiedowns. -
Page 14: Maintenance And Safety Checks
The wheelchair service provider should carry out the following checks to make sure that the seating system is both safe and suitable for the needs of the user: Check that all parts of the Kato Plus are working properly and that there are no signs of •... -
Page 15: Important Reminders
Important Reminders Carers must be aware of the following information: The Kato Plus is a custom-made device to be used only by the person it was made for. • If the user has marking on the skin or becomes uncomfortable when in the seating system, •... - Page 16 Warranty The warranty against manufacturing defects for the Kato Plus is 12 months from the date of purchase. The user should be aware that changes or modifications not expressly approved will void the warranty.
- Page 17 Notes: Manufacturer’s Label: Please attach manufacturer’s label here. 938407/2-0917...
- Page 18 938407/2-0917...
- Page 19 938407/2-0917...
-
Page 20: Qa Inspection Check List
Date Follow Blatchford: blatchford.co.uk @BlatchfordGrp 0114 263 7900 / BlatchfordGrp seatingsales@blatchford.co.uk Chas A Blatchford & Sons Ltd, 11 & 30 Atlas Way, Sheffield, S4 7QQ, United Kingdom. t: +44 (0) 114 263 7900 f: +44 (0) 114 263 7901 938407/2-0917...
Need help?
Do you have a question about the Kato Plus and is the answer not in the manual?
Questions and answers