ALDER TAPWARE Vito Bertoni LYNX ECO Instructions

Dual shower rectangular

Advertisement

alder tapware
PRODUCT: LYNX ECO DUAL SHOWER RECTANGULAR
experience that will awaken your senses and leave you satisfied and refreshed.

MAINTENANCE

This product has been meticulously engineered so that both the RAIN SHOWER and HANDSET produce luxurious shower
experiences at reduced flow rates as required by the Water Efficient Labelling Standards of Australia (WELS).
If a noticeable reduction of flow is experienced, please check the FLOW REGULATORS for foreign matter as follows:
RAIN SHOWER – unscrew to locate FLOW REGULATOR in inlet thread
HANDSET – unscrew adaptor at bottom of vertical rail to locate FLOW REGULATOR
Clean product with warm soapy water and soft cloth. Do not use abrasive cleaning solutions

OPERATION

RAIN SHOWER – operating pin at 12 o'clock position
HANDSET – operating pin at 6 o'clock position
RAIN SHOWER & HANDSET – operating pin at 9 o'clock position

WARRANTY

Warranty becomes void if:
Products exposed to pressures that exceed 500 KPA and or temperatures that exceed 75
3500.1:2003 (Clause 3.34)
Flow Regulators are removed
Product not installed in accordance with installation instructions – see over
Inadequate flushing of system prior to usage, causing damage and/or obstructions to the product.
FREECALL: 1800 800 919
®
showers have AQUAZZONE
For all servicing needs, please contact CUSTOMER SERVICE on:
PHONE: 08 6217 0600
www.aldertapware.com.au
®
TECHNOLOGY to give you an invigorating shower
FAX: 08 6217 0699
EMAIL: customer.service@aldertapware.com.au
www.vitobertoni.com.au
C within a building –
o
Refer AS/NZS
V01 190406

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Vito Bertoni LYNX ECO and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ALDER TAPWARE Vito Bertoni LYNX ECO

  • Page 1 PRODUCT: LYNX ECO DUAL SHOWER RECTANGULAR ® ® showers have AQUAZZONE TECHNOLOGY to give you an invigorating shower experience that will awaken your senses and leave you satisfied and refreshed. MAINTENANCE This product has been meticulously engineered so that both the RAIN SHOWER and HANDSET produce luxurious shower experiences at reduced flow rates as required by the Water Efficient Labelling Standards of Australia (WELS).
  • Page 2 INSTALLATION: LYNX ECO DUAL SHOWER RECTANGULAR Diagram # 1 Install G1/2 male threaded shower outlet at recommended height of 1900mm above the floor of the shower recess. The resultant height of the RAIN SHOWER is 2200mm Diagram #2 FULLY unscrew top grub screws from diverter and remove top connector piece (avoid damage to O-rings). Apply thread tape to the G1/2 male thread then screws on the top connector piece Diagram #3 Attach the square block plate to the wall using screw / plastic plug supplied.

Table of Contents

Save PDF