Summary of Contents for Caleffi solar iSolar DL3
- Page 1 Manual Mounting Electrical connection Operating controls Thank you for buying this product. Short manual Please read this manual carefully to get the best performance from this unit. Please keep this manual carefully.
-
Page 2: Table Of Contents
Proper usage Overview ........... 3 in order to avoid danger and damage to people and Included ............. 4 The iSolar DL3 is connected to controllers via the About this manual........4 property. VBus interface. It enables logging of system data and ®... -
Page 3: Overview
Overview Be it solar thermal, heating or DHW heat exchange controllers – with the DL3 you can easily and con- veniently log system data of up to 6 controllers. Get a comprehensive overview of all controllers connected with the large full graphic display. Transfer data with an SD memory card, or use the LAN interface to view and process data on your PC. -
Page 4: Included
Included About this manual This document is a short manual for the iSolar DL3. This short manual contains information about the fol- lowing topics: • Installation • Electrical connection • Operating controls • Menu • Using the SD card A detailed manual with the complete information... -
Page 5: Wall Mounting
Wall mounting Upper fastening The unit must only be located in dry interior rooms. It is not suitable for installation in hazardous locations Crosshead and should be protected against electromagnetic screw fields. Please pay attention to separate routing of sensor ca- bles and mains cables. -
Page 6: Electrical Connection
Connecting the network cable Note VBus connection at the terminals: ® The iSolar DL3 can be connected to a computer or a Connecting the device to the power sup- 1 / 2 = VBus ® connection 1 (slave) router by using a network cable (CAT5e, RJ45). -
Page 7: Operating Controls, Menu And Connections
The minimum value is indicated to the left, the status of the iSolar DL3 by issuing flashing signals. If no button has been pressed within a couple of min- maximum value to the right. The number above the Red/green flashing: The device is booting utes, the display illumination is switched off. -
Page 8: Status Display
VBus ® 1 to VBus ® 6 are displayed each in their During normal operation, the iSolar DL3 indicates the In the network display, information about the network own display. status display with the following information: connection is displayed. -
Page 9: Configuration
Configuration 5.5.2 Date and time Sensor type For the sensor inputs S1 ... S3, the following sensor In the Configuration menu, different adjustments In the Time sub-menu, the date and time can be ad- types are available: can be made. justed. -
Page 10: Logging
Î Select the right type and confirm by pressing but- • LAN can be made: ton 3. VBus.net can be used to access the iSolar DL3 over • Backup the Internet without adjusting the router . In order to If an error occurs in a sensor connection, the op- •... -
Page 11: Erase
The menu item Erase can be used to erase all logged 1 and 2, and confirm with button 3. data from the internal memory of the iSolar DL3. In Î To deactivate Auto configuration, select No and order to erase the data, proceed as follows: confirm by pressing button 3. -
Page 12: Sd Memory Card Slot
--Auto configuration Yes, No 5.10 VBus connection ® --Address The iSolar DL3 is connected to one or several con- --Mask trollers via VBus cables. The connection terminals are ® --Recover IP Yes, No located inside the housing of the iSolar DL3. -
Page 13: Firmware Update With Sd Card
New fi rmware versions extend the functional range There are 2 different ways to export logged data from and enhance the operation. the iSolar DL3: 1. Export logged data onto an SD memory card. The In order to run a fi rmware update over the SD mem-... - Page 14 Note...
- Page 15 Note...
- Page 16 CALEFFI NORTH AMERICA, Inc. Distributed by: 3883 W. Milwaukee Rd. Milwaukee, WI 53208 Tel.: +1 414.238.2360 Fax: +1 414.238.2366 www.caleffi.us sales@caleffi.com Note Important note The design and the specifications can be changed without notice. The texts and drawings in this manual are correct to the best of our knowledge. As faults can never be excluded, please note: The illustrations may differ from the original product.
Need help?
Do you have a question about the iSolar DL3 and is the answer not in the manual?
Questions and answers