Advertisement
Document Number
XM-KRECDCLPM-R0A
TROUBLESHOOTING Q & A
Q.
The search light is not operating. What might be the cause?
A.
1. Check to ensure the lamp is completely plugged into the accessory (cigarette lighter) outlet. Try rotating the plug to
make a stronger connection.
2. Check the bulb color to confirm if the bulb has burned out.
3. Examine the vehicle fuse box to see if the fuse is weak and has blown.
4. Use a voltmeter to confirm the lamp is receiving adequate input power. (If the voltage is too low, the lamp may fail to light
or restrike. If the voltage is too high, the ballast and lamp can fail prematurely.)
Q.
Can the search lamp be used for extended time periods without causing damage?
A.
All search lamps are constructed with a durable, black anodized aluminum body with a die-cast, textured-finish handle.
Occasionally, the lamp may feel warm to the touch, but it is made to withstand continuous operation.
OPTIONS
Part Number
CD-DMB-CL
CD-RR-1
CD-H2100W Spot
CD-H225W12 Flood
CD-H1100W
NOTES:
Mounting Bracket—Part Number CD-DMB-CL: It is highly recommended to use Lens Gaskets (Rubber Rings) with
the mounting bracket.
Part Number CD-RR-MAG (Lens Gasket), comes standard with the CD-MAGNUM.
CD-CL-12-M: Handheld spotlight with Momentary Switch
CD-MAGNUM
1.
Remove the rear cap by twisting counter-clockwise.
2.
Withdraw the bulb mount assembly from the
reflector housing.
3. Unscrew the rear bulb mount section, remove the
old bulb.
4. Insert a new bulb into the bulb mount. Use cloth.
Screw the sections back together.
5. Install the assembled bulb mount into the housing
reflector alignment hole.
6. Replace the cap, mate spring with bulb mount and
tighten clockwise.
Description
Mounting Bracket
Lens Gasket
Spot Replacement Bulb
Flood Replacement Bulb
Spot Replacement Bulb
BULB REPLACEMENT
Caution: Do not touch the glass bulb of the lamp.
If necessary, clean with isopropyl alcohol.
Used with Lamp Part Number
CD-MAGNUM, CD-CL-12 or CD-CL-HID-1
CD-CL-12 or CD-CL-HID-1
CD-CL-12
CD-CL-12
CD-MAGNUM
CD-CL-12
1.
Remove the rear cap by twisting counter-clockwise.
2.
Grasp the bulb mount assembly and withdraw from
the head. Separate the sections.
3.
Remove the bulb to be replaced. Use cloth. Insert
a new bulb and check for proper alignment.
4.
Connect the bulb mount sections and slide into the
head. Note alignment slots.
5. Check the alignment in the reflector. Two dowel
pins must protrude through reflector for proper
alignment.
6.
Replace the cap onto the head, twist clockwise to lock.
CDCL-Rev151026
Advertisement
