Zamp Solar ZS-BRK-AS Quick Start Manual

Installation Instructions
1. Find placement for your panel(s) on roof and foot
placement on the panels.
2. Install mounting feet to panel by following the steps below.
3. Figure 1. Insert 4 x T-Nuts into the frame on the edge
where you will be placing the tall feet.
4. With T-Nuts inserted into the frame place the tall feet along
the frame as seen in Figure 2. Then use the hex nuts and
lock washers to secure the feet to the frame.
5. On the side of the panel where you will have the short feet
you will be screwing the bracket into the frame with the
provided self-tapping screws. See Figure 3.
6. With all mounting feet secured to the panel place the
panel on the roof and mark the location of the screw holes
on the roof of your RV.
5. Drill holes as indicated by the marks from previous step.
6. Apply a generous amount of sealant to the RV roof
where mounting feet and screws will be placed.
7. Place panels over the marked areas covered in sealant and
drill through the roof of the RV.
8. To secure the panels to your roof screw the panels onto the
roof with appropriate hardware (not provided).
9. Retighten as needed.
* Reach out to your RV manufacturer to find the appropriate hardware to secure
the panels to your RV roof
Curved Roof Mounting Feet Quick Start Guide
Curved Roof Mounting Feet Components
· A: 2 x short feet · B: 2 x tall feet
· C: 4 x T-Nuts · D: 4 x Lock Washers
· E: 4 x Hex Bolts · F: 6 x Self-Tapping
Screws