How To Use - HoMedics mybaby MYB-W10-CA Instruction Manual And Warranty Information

How To Use

1. Lift the cover to the Soap Reservoir, remove the plug and fill the reservoir up
Caution: All
2. Open the Battery & Control Compartment on the bottom of the unit and press
servicing of
this product
must be
performed by
authorized
3. Attach the Drip Tray by placing as shown below.
HoMedics
Service
4. Place your hand under the spout to activate the Motion Sensor.
Personnel
only.
How to use the CLEAN Function: If you wish to change the type of soap in the Dispenser,
you may use the CLEAN function to empty and clean the unit. Open the Battery/Control
Compartment door (Figure 2).
Soap Reservoir
to the "MAX" line. Do not overfill as this may cause dripping. Replace the plug
in the soap reservoir securely.
the POWER button. The Red LED will turn on for 12 seconds while the unit is in
Setup Mode. During this period, the Motion Sensor and motor will not function.
This will allow enough time to close the Battery & Control Compartment door
and position the unit without triggering the Motion Sensor.
Magnets help to secure in position.
The Soap Dispenser will then dispense soap and play the training Song.
Note: The Soap Dispenser will automatically turn the Song Mode to ON
when the device is powered ON. To turn Song Mode OFF, press the
SONG button (Figure 2) once.
Figure 3
3
Spout
Red LED:
Indicates Motion Sensor
is not active during Setup
Mode; Flashes to indicate
low battery condition
Motion Sensor
Drip Tray