Turn on Progressive Scan
If the TV supports progressive scan output, you
can connect this Home Theater System and the
TV using component video connection. (see
'Connect video cables' > 'Option 2: Connect to
the component video jack').
Video Setup
TV System
TV Display
Progressive
Picture Setting
1
Turn on the TV and ensure that the TV
progressive scan mode is deactivated (see
the TV user manual).
2
Switch the TV to the correct viewing
channel for this Home Theater System.
3
Press DISC .
4
Press
SETUP .
5
to select [Video Setup] in the
Press
menu, then press .
6
Select [Progressive] > [On] , then press
OK .
A warning message is displayed.
»
7
To proceed, select [Ok] and press OK .
The progressive setup is complete.
»
Note
•
If a blank/distorted screen is displayed, wait for
15 seconds for the auto recover.
•
If no picture displayed, turn off the progressive
scan mode as follows: 1) Press to open
the disc compartment. 2) Press . 3) Press
AUDIO SYNC .
8
Press
SETUP to exit the menu.
9
You can now turn on the progressive scan
mode on the TV.
16
EN
On
Off
Note
•
During play, when progressive scan mode is on
for both this Home Theater System and the
TV, distorted picture may display. Turn off the
progressive scan feature on both this Home
Theater System and the TV.
Change speaker settings
Ideally, the distance between listening position
and all the speakers should be the same. If not,
change the speaker settings based on their
distance from the listening position to obtain
the best possible surround sound.
Audio Setup
Speakers Volume
Speakers Delay
Night Mode
CD Upsampling
1
Press DISC .
2
SETUP .
Press
3
Press
to select [Audio Setup] in the
menu, then press .
•
If the speaker setup option is not
accessible, press
try the above steps again.
To set the speakers level
1
Select [Speakers Volume] in the menu,
then press .
twice before you