Advertisement
Button Instruction
1. Manual Defrost/Stop Defrost
Hold
and
for 5 seconds.
2. Panel Parameter Lock
Hold
and
SET
for 3 seconds. DIsplay "00" for lock status and "33" for
unlock status. When locked, only setpoint is able for setting.
3. Evaporator temperature
Hold
for one second to display. It will switch back to indoor tempera-
ture after 3 seconds. The rest parameter setting cannot be changed.
4. Parameter Value Increase
Value increase with
button pressed.
5. Default Setting Restore:
Unplug the power line, hole
明
除t雾
Light
Wiring Instruction
DEFROST
P13
1
P12
G
G
G
G
P11
NEB
1 3W
User's wiring
0800 503 335 • ordernz@southernhospitality.co.nz • www.southernhospitality.co.nz
UP
and
SET
then plug in to display rS.
Defog
MADE IN TAIWAN
DEFOG
DOWN
1. Manual Defrost/Stop Defrost
Up: ON
Down: OFF
Hold
2. Quick Setting
LIGHT
Press
If no action occurs within 5 seconds, or press
Up: ON
parameter automatically, and indoor temperature displayed.
Down: OFF
LIGHT
DEFOG
COMP
FAN
2A
P7
FAN
1.5HP/240VAC
1HP/120VAC
AC2
RLY5
RLY4
P9
2
AC2
P5
COMP
DEFROST
1. Panel Parameter Lock
Hold
and
SET
for 3 seconds. DIsplay "00" for lock status and
"33" for unlock status.
When locked, only setpoint is able for setting.
2. User's Parameter Option
Hold
SET
for 3 seconds to enter parameter setting. "Temp. Set"
is ON. Press
SET
for one second, the parameter can be adjusted
accordingly.
3.Release Quick Setting Mode
In quick setting mode, press
4. Default Setting Restore:
Unplug the power line, hole
display rS.
溫度設定
Temp. Set
Temp
Operation
除霜時間
Defrost
and
for 5 seconds.
for one second, then press
or
P1
P2
10A
10A
10A
SET
SET
or any other button.
and
then plug in to
SET
SET
POWER
ON/OFF
RS-617S
Hold
3 seconds to
power on/off
to adjust setpoint.
SET
directly to restore
P1: Connect with operation panel.
Power supply: AC 110V-220V ± 10% single
phase 50/60Hz
Power consumption: Max. 10 Watt
(Controller only)
Reading range: —45°C - 45°C ± 1°C
The output contact capacity show in the
wiring diagram. Do not overload.
If the compressor uses 220V, but the other
devices are 110V, connect their common
line to #G instead of #AC1
Before applying power to the unit,
always check if the voltage set correctly
according to the input voltage.
for
Advertisement
