Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Grundfos PM Rain
Summary of Contents for Grundfos PM Rain
- Page 1 GRUNDFOS INSTRUCTIONS PM Rain Installation and operating instructions...
- Page 2 Declaration of conformity EC declaration of conformity We, Grundfos, declare under our sole responsibility that the products PM Rain, to which this declaration relates, are in conformity with these Council directives on the approximation of the laws of the EC member states: –...
-
Page 3: Table Of Contents
2. Scope of supply 8.1 Anti-cycling • Grundfos PM Rain unit. 8.2 Dry-running protection • Grundfos PM Rain unit and SB pump. Frost protection • Grundfos PM Rain unit and JP pump. 10. List of warnings Supplied with an automatic air release valve fitted in the priming hole and unions. -
Page 4: Applications
When the rainwater tank is filled with rainwater again, the PM Rain will automatically switch back so that it supplies rainwater instead of mains water. The PM Rain automatically starts and stops the pump according to the water demand. -
Page 5: Mechanical Installation
Maximum height [bar] [kPa] 2.5* Mains water Fig. 2 PM Rain and JP pump We recommend PM Rain and JP pump for positively fed systems only, for Note example above-ground collecting tanks. * Default setting. See section 5.1 DIP switches. -
Page 6: Pressure Settings
10. Refit the PM Rain cover. Pos. C in fig. 4: 11. Insert the pump cable plug into the PM Rain unit. The unit should be installed so that the control panel 4.4.2 Aligning pressure settings is visible and easily accessible. Ensure that the inlets and outlets are connected correctly. -
Page 7: Electrical Installation
The red indicator light is tripping current < 30 mA. permanently on or flashes The PM Rain unit has a male plug for power supply in case of a fault. and a female socket for pump supply. See section 12. Fault "Warning"... -
Page 8: Dip Switches
5.1 DIP switches 5.2 Enabling the DIP switch settings The PM Rain has a number of settings which can be When the desired DIP switch settings have been made with the DIP switches behind the control panel. made, they must be enabled, otherwise the PM Rain See fig. -
Page 9: Start-Up
See fig. 7. – The pump is running. If rainwater is no longer available, the PM Rain will 4. Close the tap. stop the pump when dry running occurs. When the system pressure drops below 2.5 bar (250 kPa), the –... -
Page 10: Caution
When the auto-reset function is enabled, cycling and dry-running warnings will be automatically reset. As default, the PM Rain is set to this operating mode, i.e. DIP switch 5 set to "OFF". To enable the function, set DIP switch 6 to "ON". -
Page 11: Frost Protection
8.2.3 Resetting of dry-running warning Manual resetting If a dry-running warning has been activated, the pump can be restarted manually by pressing [Reset]. If the unit detects no pressure and no flow within 40 seconds after restarting, the dry-running warning is re-activated. -
Page 12: List Of Warnings
Protection mode. Note: The protection mode will protect the times per period. installation when the PM Rain is set to start/stop with 1 bar (100 kPa) differential pressure, i.e. when DIP switch 5 is set to "ON". The protection mode functions independently of the anti-cycling function. -
Page 13: Fault Finding
12. Fault finding Warning Before starting work on the pump/PM Rain, make sure that the power supply has been switched off and that it cannot be accidentally switched on. Fault Cause Remedy The pump runs Air lock in the system. -
Page 14: Further Product Information
Set DIP switch 5 to "OFF". seconds. a short period. The PM Rain is set to start/stop with 1 bar (100 kPa) differential pressure, i.e. DIP switch 5 is set to "ON", but no pressure tank has been installed in the system. - Page 15 Appendix 1x230 V 50/60 Hz, PE 1x230 V 50/60 Hz, PE Fig. 8 Wiring diagrams Fig. 9 Dimensions...
- Page 19 Australia Malaysia Taiwan GRUNDFOS Pumps Pty. Ltd. GRUNDFOS Pumps Sdn. Bhd. GRUNDFOS Pumps (Taiwan) Ltd. P.O. Box 2040 7 Jalan Peguam U1/25 7 Floor, 219 Min-Chuan Road Regency Park Glenmarie Industrial Park Taichung, Taiwan, R.O.C. South Australia 5942 40150 Shah Alam...
- Page 20 Thinking ahead makes it possible Innovation is the essence 98097101 1211 ECM: 1082500 The name Grundfos, the Grundfos logo, and the payoff Be–Think–Innovate are registrated trademarks owned by Grundfos Management A/S or Grundfos A/S, Denmark. All rights reserved worldwide. www.grundfos.com...
Need help?
Do you have a question about the PM Rain and is the answer not in the manual?
Questions and answers