Advertisement
battery. For safety and environmental reasons DO NOT discard
in domestic waste or by burning. ONLY discard or recycle
according to local authority regulations.
WARNING! DO NOT allow a leaking battery to contact your
person. If you come into contact with battery liquid take the
following immediate action:
a) Skin contact: Wash immediately with soap and water,
then wash flesh in either lemon juice or vinegar.
b) Eye contact: Wash with a strong solution of boric acid,
and seek immediate medical attention.
1.4
Wiring a BS 1363/A UK 3 Pin Plug
If in doubt contact a qualified electrician.
a) Connect the GREEN/YELLOW earth wire to the earth
terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal
'N'.
d) After wiring, check that there are no bare wires, that
all wires have been correctly connected, that the cable
outer insulation extends beyond the cable restraint and
that the restraint is tight.
Double insulated products, which are always marked with this
symbol
, are fitted with live (brown) and neutral (blue) wires
only. To rewire, connect the wires as indicated in diagram.
DO NOT connect either wire to the earth terminal.
fig.1
RECOMMENDED
FUSE RATING:
3 AMP
2. INTRODUCTION & SPECIFICATIONS
Lightweight and compact design. Features heavy-duty alloy bevel
gear head with aluminium gear casing and adjustable grinding disc
guard. Features spindle lock for quick disc changes. Supplied with
side handle and soft grip body for added comfort and control.
Powered by Lithium-ion battery, which maintains a high energy
density level with a flat discharge curve - performing better and
longer than a conventional Ni-CD/Ni-MH battery. No memory effect
allows the battery to recover from a deep discharge with no tendency
to reduce overall capacity. Supplied with 1 hour mains charger, two
batteries, pinned wrench, hex key and canvas storage bag.
Model No: ............................................................................. CP5418V
Battery type: ...............................................................Li-ion 18V 1.3Ah
Disc Size: ............................................................................... Ø115mm
Spindle Thread Size: ..................................................................... M10
Motor Power: ............................................................................... 800W
No Load Speed: ..................................................................... 7000rpm
Noise Power: ...................................................................... 87.67dB(A)
[Certainty value] (K):.................................................................. 3dB(A)
Noise Pressure: .................................................................. 76.67dB(A)
[Certainty value] (K):.................................................................. 3dB(A)
Replacement battery: ....................................................... CP5418VBP
Weight (including battery): ............................................................3.5kg
© Jack Sealey Limited
Grinder profile, battery fitted, grinding disc not fitted
I/O Switch, slide
fully up to start,
press I/O tab end
to stop.
fig.4
Depress buttons to
remove from grinder
Slide on fully, depress buttons to slide off
fig.5
Amber LED
fig.6
Red LED
Green LED
Original Language Version
fig.2
Fit handle either side
Press to lock
gearbox
Latch
Green LED
Red LED
Press to check
battery status.
View on rear of battery
Charger base, battery fully engaged
CP5418V Issue: 2(L) - 21/02/14
fig.3
Advertisement
