Advertisement
The OpenChord.org
V1 guitar
Programming in Note Mode
However, the V1 is not limited to one pre-programmed scale. By accessing the
configuration mode, you can re-map the buttons to any number of notes on the guitar.
This new programming will be preserved even when you unplug the guitar (to restore
the defaults, see the Resetting the Guitar section). Again, since the feedback is provided
through the status of the buttons, it is recommended that you configure the guitar during
a song or practice mode.
▲Entering Configuration Mode
▲Entering Configuration Mode
fig12. – Configuration Mode
Upon entering Configuration Mode,
the green button will light up,
signaling that you are currently
programming the green button. Hold
the note you'd like to map to green
and press the "+" button on the V1.
fig 14 – Programming the Green Button
By pressing the 4th, 5th, and 6th
strings on the 5th fret, the
controller
enters
Configuration Mode. To exit
configuration
Mode,
press the 3rd, 4th, and 5th
strings on the 5th fret.
fig 13. – Entering
Configuration Mode
into
simply
Advertisement
