Advertisement
Document No. 129-406
Installation Instructions
October 5, 2009
Connecting Communications and Power
1.
Connect the RJ11 communications line from the
TTX to the RTS/MMI connector on the TEC
(Figure 1).
2.
Connect the TTX power wires as follows:
a. If possible, connect the TTX power wires
directly to the TEC H (hot, 24 Vac, red) and
C (common) power terminals (Figure 1).
b. If direct connection to the TEC power terminals
is not possible, locate the jacketed 24 Vac TEC
power wires from the transformer. Connect the
TTX power wires to the TEC power wires using
the power connectors provided. See Figure 1.
Figure 1. TTX Mounting and Connections. Dimensions in Inches (Millimeters).
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models as
design improvements are introduced. Heyco is a registered trademark of Heyco Products, Inc. Scotchlok a trademark of 3M. Other product or
company names mentioned herein may be the trademarks of their respective owners. © 2009 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089
+ 1 847-215-1000
NOTES: 1. The 3M Scotchlok™ power connector is an
The installation is now complete.
Your feedback is important to us. If you have
comments about this document, please send them to
sbt_technical.editor.us.sbt@siemens.com
insulation displacement connector.
Therefore, removing wire insulation is not
necessary.
2. The 3M Scotchlok power connectors can
be used one time only. Once they are
clamped in place, they cannot be removed
and reused. Additional 3M Scotchlok power
connectors are available from
W.W. Grainger, Inc. (part number 4YT73)
via the Field Purchasing Guide.
Document No. 129-406
Printed in the USA
Page 2 of 2
Advertisement
