Summary of Contents for Tanks Direct AquaTank
- Page 1 AquaTank Installation & Technical Details www.tanks-direct.co.uk 01643 703 358 Version 1.0 - Updated 08/01/2015...
- Page 2 Inlet The AquaTank is provided with a 110mm inlet seal, this is supplied loose. You only need to use this seal if you wish to add an inlet from a channel wall (as well as the clear opening at the top of the chamber).
- Page 3 8. The alarm panel housing (if applicable) must be sited adjacent to the AquaTank with 40mm cable duct (with draw cord) for the cabling. If the control panel is not to be sited adjacent to the AquaTank, DP&T should be advised at order stage so that we can make recommendations as to the cabling requirements.
- Page 4 Single Drainage Sump & Pump Installaton Instructions and Technical Details High Level Alarm The High Level Alarm is mounted adjacent to the AquaTank. An audible signal will be heard in the case of pump failure. Wiring Diagram The float for the High Level Alarm should be attached to the pump, see picture below.