NHR SG-01-SK-HB User Manual

ZigBee Wireless Fire Smoke Alarm
(Photoelectric detection type / Battery-powered / Voice alarm)
Model: SG-01-SK-SB for stand-alone / SG-01-SK-HB for ZigBee

User Manual

※ Compliant to local legal requirements
※ For Indoor use
※ Contain installation procedure
◤ Thank you for choosing Nietzsche's photoelectric type fire smoke detector.
◤ Please read the manual carefully and use the detector properly.
◤ Please read every details in the manual and notice every "Warning"carefully.
Before installing the detector
使用前
◤ The sensing technology of this detector is photoelectric smoke detection.
◤ The detector reports possible fire alarm, but user should not expect there will
not be any fire event because installing the detector, please note Nietzsche
take no responsibility for any damages from any accident in any case.
◤ Please note sprinkling-type of pesticide will effect the function of the detector.

1. Safety Notice

To protect your safety , please note below safety notice. Please make
sure the Site of installation is safe during your installation, watch your
feet and position, danger could happen if you do not keep your eyes
on your environment.
Please keep tools, such as battery, screws and screw drivers away
from children. Children could accidentally swallow or hurt themselves
if they get those tools.
Please keep your ears a certain distance from the siren, it may hurt
your ability of hearing if you get too close to the siren while it is
activated at the time.

2. Notice in use

◤ According to the law, customer must install the detector(s) in indoor and
--maintain/ manage the detector's operation on their own.
◤ Please check if the detector still working properly every six months to make
--sure its functions.
◤ Please do not disassemble, modify, scratch, paint or shocking impact on the
--detector, it may cause damage of the detector.
◤ Please note the detector has self-detection and low-battery alarm, please be
--aware of any indication from the detector no matter it is flash in LEDs or beep,
--and read manual to find out the meanings.
◤ Photoelectric type smoke detector alerts only for the smoke around it, the
--detector may not report event for another room.
◤ Please make sure user can hear the alarm when installing the detector in less
--used room.
◤ Please make sure the pesticide may effect the functions of the detector, please
--withdraw or spread the pesticide in the place where it will not effect the detector.
◤ Please double check if the detector still works normally whenever you are
--back home after 7 days or more than 7 days trip.

3. Detector introduction

Test button/
Mute button
The detector Alert LED : Red
Fixture Smoke detection Siren speaker
chamber
What is included in the box
◤ Screws for wall/ceiling mount (3.5 x 25mm)..............................2 pieces
◤ Screws cap for screws ......................................................2 pieces
◤ Battery (CR123A) ............................................................ 1 piece
◤ Manual ........................................................................1 piece
Warning
Please make sure the battery is away from children, it will hurt
children if they accidentally swallow the battery.

4. Location of Installation

Hallway/
Bed room Baby room Living room
Corridor
Photoelectric Type Fire Smoke detector

5. Installation Position

※ Ceiling-mounted
Within
Within
60 cm
60 cm
Within
60 cm
◤ Installing the detector away
◤ The detector should ◤ Installing position
should away from the
from the ventilation at least
be less than 60 cm from
ridge beam or wall at
1.5 meters to avoid the false
the ridge beam.
least 60 cm, and best
alarm caused from the air flow.
position it in the center
of the room.
※ Wall-mounted
over
Wireless Link
15cm
Status button
(S1)
* Places where the photoelectric type detector should avoid installing:
(1) Cooking area with frequently smoke or steam generating; (2) Places where
Wireless Link
the temperature goes sub-zero 。 C/ 32 。 F, or over 50 。 C/ 122 。 F in that it is easy
LED : Green
to damage the battery and end up causing false alarm or low battery;
(3) Outdoor is not allowed to be installed; (4) Bathroom or any places where
frequently wet or in high humidity places; (5) Places besides Lamp or lights
that may block fire smoke are not allowed to install the detector, please keep
those equipment at least for over 50 cm.
There are two ways of mounting the detector, wall-mounted and
ceiling-mounted.
Please make sure your personal safety in mounting the detector,
position in installing the detector is very important and should pay
high attention to avoid accidents.
Please make sure the screws have been fixed tightly on wall, any
fallen parts or detectors itself may cause damage of the detector.
Please strengthen the wall or ceiling with a supplement board in
softer wall or ceiling to avoid the damage cause from fallen parts
or detector.
Stair Kitchen
Please make sure the screws or any wooden dust will not fall into
eyes during installation. Please clean the dust as soon as possible
Heat
detection if it happens and call doctor for careful check of health of installer.
type
1. Open the mounting bracket, and put in the battery.
2. Please write down installing date on the detector in the position where agent
has suggested.
3. Please press Test Button one time and wait for a Beep to ensure the proper
detector setup.
4. Please make sure the linking status for the wireless type. Green LED flashes
every 65 seconds in normal status.
Away from ventilation
over at least 1.5 meters
Negative
pole -
◤ Please install the detector over 15 cm and within
60 cm from the ceiling in wall-mounted style.
Warning
within
60cm
Please install the detector as centered
as possible, false alarm could happen
frequently because of inappropriately
installing position.

6. How to mount the detector

Warning

7. Procedure of installation - Preparation

Positive pole +
Battery model: CR123A
Installed
on yy / mm
1/2