To Select Connected Equipment; Cinema Link Surround Receiver; Recorder Or Dvd With Easylink - Philips 32PW9768/05 User Manual

Connect extra loudspeakers/amplifier
multimedia loudspeakers
REAR
&
Select Surround speakers On
menu, see p. 7.
é Connect the audio cables to the rear
loudspeakers and to the Dolby Surround
output
SURROUND OUT
TV.There is only one output for both speakers.
"
Adjust the volume of the rear loudspeakers.
Use the Test tone function in the Speakers
menu, see p. 7.
Note: Once you have adjusted the volume of the
rear loudspeakers, do not change it while watching
TV as the whole configuration operates with the
volume adjustment of your TV.
AUDIO

To select connected equipment

Press the v key on the remote control repeatedly to select
according to where you connected your equipment at the back or the right side of your TV.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.

Cinema Link surround receiver

See the separate supplied Cinema Link instruction manual.
Attention: the sound info on screen will not correspond with the actual sound reproduction.

Recorder or DVD with EasyLink

The recorder (VCR or DVD+RW) or DVD can be
operated with the remote control via the
or menu on screen.
Recorder
DVD
Recorder
Ò
Rwd Play
DVD
Ò p
Prev. Play
24
in the Setup
at the back of your
Surround out
p ‡ π †
Stop Play Ffw
‡ π †
Stop Play Next Eject
(Analogue) MultiChannel surround receiver
&
Connect a MultiChannel surround receiver to
the
AUDIO OUT R
back of your TV.
é
If you want the loudspeakers of your TV to act
as centre speaker, also connect an audio cable
to the MultiChannel surround receiver
CENTRE OUT
connector at the back of your TV.
IN
" Select
See p. 9.The loudspeakers of the TV will now
only produce centre sound.
'
If necessary, adjust the volume level of the
centre sound in the
item of the Source menu.The overall volume
has to be controlled via the MultiChannel
surround receiver.
AUDIO
OUT
EXT1
&
Press the
control.
é Select the
cursor up/down.
"
Press the cursor left/right, up/down to select
®
Ï
one of the recorder or DVD functions.
Rec Eject
If your EasyLink recorder has the system standby
function, when you press the B key for 3 seconds,
Ï
both TV and the recorder are switched to standby.
and connectors at the
L
connector and to the
in the Source menu;
Centre input On
Centre in volume
, , ,
EXT2 EXT3 EXT4
Ï key on the remote
MENU
or
Recorder
DVD
CENTRE
menu
CENTRE IN CENTRE IN CENTRE IN
or
SIDE
menu with the