English - i-tec PCE2U31AC User Manual

PCI-E USB 3.0/3.1 Card
PCI-E adapter for 1x external USB-A 3.1, 1x external USB-C 3.1, 1x additional
power SATA 15pin
INTRODUCTION
Internal PCI-E card to your desktop computer. Extend your PC by two USB
connectors that allow you to connect additional peripherals to your computer.
The card is equipped with external USB-A 3.1 and USB-C 3.1 connectors. USB-C
also allows for transfer speeds up to 10 Gbps.
PACKAGE CONTENTS
• i-tec PCI-E USB 3.1 Card
• Extra Low Profile Backplate
• Manual
SPECIFICATIONS
• Supports 1x USB-A 3.0 and 1x USB-C 3.1 second gene.
• Supports 4-line PCI Express v2.0
• Supports Power Management PCI Express Link
• Supports PCI Express interface
• Complies with USB 3.1 specification
• Compatible with USB 3.0, 2.0 and 1.1
• Support for data transmission of 10 Gbps, 5 Gbps, 480 Mbps, 12 Mbps
• Possibility of rapid charging via USB-C port (current up to 3A)
• Supports UASP and BOT transmission mode
• Max. value 5V/900 mA at USB-A port output
• Max. value 5V/3000 mA at USB-C port output
• Power connector SATA 15pin
• Supports remote access and standby mode
• Supports Windows OS Windows 7 / 8 / 10 32/64- bit, Linux Kernel 2.6 and
later
SYSTEM REQUIREMENTS
• PC with installed Windows 7 / 8 / 10 32/64- bit, Linux Kernel 2.6 and later
• One free PCI Express slot (recommended with support for PCIe 2.0) x4
HARDWARE INSTALLATION
1. Turn off your computer and unplug its supply from the mains.
2. Remove the PC cover, position and screw PCIe card to a free PCIe slot (break
off an appropriate cover of a corresponding slot on the rear of the PC casing).
3. Connect auxiliary 15-pin power port SATA with an available connector on the
PC power supply. PCIe card will not work without connecting SATA power!
4. Then cover the PC, connect it to the mains and then start the computer.
4 |

ENGLISH