Product function • 7 inch digital panel Screen Ratio: 16: 9 • Resolution: 800*RGB*480 • Front Key Function: 7pcs mechanical keys • Remote Control Function: Small six key remote control • 1 wireless video input • 1 wireless audio input •...
3.Product Introduction A. Front Panel Introduction Monitor Panel Introduction 9 10 2.4G antenna Display screen Metal LOGO plate MENU: open or exit the menu Brightness decrease: decrease the screen brightness value Brightness increase: increase the screen brightness value Power: Under power off state, press shortly to start up, press and hold to power off; under power on state, press shortly to close the display screen, press and hold to power off Volume decrease: decrease the volume Volume increase: increase the volume...
Camera Introduction 1、2.4G antenna 2、U shaped bracket and sun shade 3、Power cable: DC 12-24V input 4、Pairing button B.Menu Settings Introduction 1.Pairing setting Press the “MENU” key on the panel or remote control to open the menu interface; then press “ ”...
Page 5
2、Camera brightness Setting Press “ ” on the panel or “VIDEO” “MODE” on remote control to switch to “Brightness” option, and then press “ ” on the panel or “LEFT” “RIGHT”on remote control to open the camera brightness setting and adjust the specific parameters.
Page 6
press “ ” on the panel or “LEFT” “RIGHT”on remote control to open the camera saturation setting and adjust the specific parameters. Just as shown in the following pictures. 5、Language setting Press “ ” on the panel or “VIDEO” “MODE”on remote control to switch to“Language”option, and then press “...
Page 7
“ ” on the panel or “LEFT” “RIGHT” on remote control to “Delay” option and press them again to set the delay time. There are 0 sec, 5 sec and 10 sec optional. The default value is 0 sec, closed. Just as shown in the following pictures.
Page 8
10、Reset Setting Press “ ” on the panel or “VIDEO” “MODE” on remote control to switch to “ Others” option, and then press “ ” on the panel or “LEFT” “RIGHT”on remote control to the “Reset” option and press them again to confirm or cancel recover to factory settings.
1、 Monitor 2、 Camera 3、 Camera Pairing button 4、 Camera power supply port: DC12-24V input 5、 Monitor power supply port: DC12-24V input 6、 Reversing trigger line Power extension cable 7、 Red electronic wire: DC12-24V power input 8、 Black electronic wire: GND 9、...
Need help?
Do you have a question about the SM-7070WR and is the answer not in the manual?
Questions and answers