Bullard TrakLite Use And Operation

The Bullard TrakLite is the first integrated helmet light available for American-
style fire helmets. The TrakLite illuminates dark, low visibility areas via eight
bright LED lights mounted to the front of the helmet and includes a blue
LED indicator light mounted on the rear of the helmet for crew tracking and
accountability. The integration of the TrakLite into Bullard fire helmets enables
straightforward operation and maintenance. The TrakLite is compatible with
Bullard UST6, FX, PX and LT Series structural fire fighting helmets.
Use and Operation

Powering the TrakLite

THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I, DIVISION 2, GROUPS A,
B, C, D OR NON-HAZARDOUS LOCATIONS ONLY.
The oversized power switch on the TrakLite is designed for easy operation
with a large gloved hand (Figure 1). The rotary switch operates simply with a
quarter turn and stops at the ON and OFF positions, enabling easy operation
while wearing the helmet. To power on the TrakLite, turn the switch clockwise
until the indicator is pointed to the ON position. To power off the unit, turn the
switch counterclockwise so that the indicator is pointed to the OFF position.
When powered on, both the front and rear lights will illuminate and will
continue to illuminate until powered off.
Figure 1

Battery Installation and Replacement

WARNING
EXPLOSION HAZARD - BATTERIES MUST BE CHANGED OR REMOVED IN AN
AREA KNOWN TO BE NON-HAZARDOUS.
The Bullard TrakLite is operated by four (4) replaceable AAA alkaline batteries
(included). The battery housing is located under the helmet brim at the
rear of the helmet. Prior to opening the battery housing lid, wipe down the
helmet and battery housing to make sure no debris falls into the battery
compartment.
To install or replace the batteries, use a Phillips head screwdriver to remove
the two screws securing the battery housing lid to the battery housing (Figure
2) and remove the battery housing lid. Install the batteries according to the
polarity (+ and – indicators) in the battery housing. When finished, replace
the battery housing lid and securely fasten using the screw.
Figure 2
TrakLite
®
Only install the batteries as directed in this manual and in accordance with the
polarity indications in the battery housing (Figure 2). Failure to observe this
warning may result in battery damage, product damage and/or serious injury.

Care Instructions

EXPLOSION HAZARD - Substitution of components may impair suitability for
Class I, Division 2.
After each use or as needed, clean the light housing, glass windows, and
battery housing with mild soap and detergent ensuring that the battery
compartment remains dry and clean.
Do not open in a potentially explosive area or zone.
Do not use solvents or paint thinners to clean the TrakLite, as they could
permanently mar the surface or degrade the protective properties of the
casing. Clean only with a damp cloth in a non-hazardous area. Do not
submerge the helmet or any part of the TrakLite in water or other liquids
and do not expose the TrakLite to high pressure water.
www.bullard.com
Fire Helmet Lighting System
Use and Operation
WARNING
WARNING
CAUTION