Table of Contents
Advertisement
Adjusting the Manual Converge Controls
M
ULTIPOINT
T
he Multipoint Red/Blue Convergence controls enable you to
adjust the convergence at specific points on the TV screen.
NOTE: The onscreen display will leave the screen after 20
seconds of inactivity. If this happens, simply press the MENU
button to bring the MANUAL CONVERGE submenu back.
1
Press the MENU button. The menu appears. Press the
CURSOR BUTTON RIGHT to enter the PICTURE
menu. Then press the CURSOR BUTTON DOWN until
MANUAL CONVERGE is highlighted.
2
Press the CURSOR BUTTON RIGHT to enter the
MANUAL CONVERGE submenu. Press the CURSOR
BUTTON DOWN until MULTIPOINT RED or MULTI-
POINT BLUE is highlighted. Then press the CURSOR
BUTTON LEFT or RIGHT to enter Navigate mode.
3
Press the CURSOR BUTTON LEFT, RIGHT, UP, or
DOWN to move to a cross hair that has a color outline.
Then press the EXIT/INFO button to enter adjust mode.
4
Press the CURSOR BUTTON LEFT, RIGHT, UP, or
DOWN to adjust the cross hair image until the color
outline is gone.Then press the EXIT button to return to
NAVIGATE mode. Repeat steps 3 and 4 until all
misaligned cross images have been adjusted.
5
After making your adjustments, you must store them in
the
TV's
memory
NOTE: If you are not satisfied with the adjustments you
just made and want to start over, you can use the UNDO
MULTIPOINT control. This control allows you to undo the
adjustments, but it will work only if you use it before
saving.
To save your multipoint adjustments, press the MENU
button. This returns you to the MANUAL CONVERGE
menu. Press the CURSOR BUTTON DOWN until SAVE
MULTIPOINT is highlighted. Then press the CURSOR
BUTTON LEFT or RIGHT to store your adjustments in
the TV's memory.
OR
To undo the multipoint adjustments you just made,
press the MENU button. This returns you to the MANUAL
CONVERGE menu. Press the CURSOR BUTTON
DOWN until UNDO MULTIPOINT is highlighted. Press
the CURSOR BUTTON LEFT or RIGHT to undo the
adjustments. Press the CURSOR BUTTON UP until
MULTIPOINT RED or MULTIPOINT BLUE is highlighted.
Press the CURSOR BUTTON LEFT or RIGHT to enter
Navigate mode. Then Follow steps 3–5 above to make your
adjustments again.
OR
To restore the TV's convergence to factory settings,
press the MENU button. This returns you to the MANUAL
CONVERGE menu. Press the CURSOR BUTTON
DOWN until RESTORE FACTORY is highlighted. Then
press the CURSOR BUTTON LEFT or RIGHT to restore
the TV's convergence to factory settings.
6
Press the EXIT/INFO button to exit the submenu.
A
M
DJUSTING THE
R
/B
ED
LUE
using
SAVE MULTIPOINT.
C
ANUAL
ONVERGE
18
C
ONTROLS
H
H
ELPFUL
If you should experience a power outage
before saving your multipoint-convergence
settings, your settings will be lost.
INT
Advertisement
Table of Contents
