Selecon Studio Panel Manual Addendum

Studio Panel LED Luminaires
MANUAL ADDENDUM - PLEASE READ
1. Overview
This MANUAL ADDENDUM provides information in addition to the Installation and User's Manual supplied with
the unit. Please review this document - as well as the supplied manual - carefully before using the Studio Panel LED
Luminaire.
Some notes about this document:
• Your Studio Panel LED Luminaire has been updated with the latest firmware (version 1.2 or later).
• Please refer to the new menu categories and options table and custom recording options below.
• Table 1 in this addendum supersedes Table 5 on page 13 of the installation and user's manual.
2. Updated Menu Categories and Options
Note: All options in grey shading are added in software version 1.2 (or later). All other options remain unchanged.
Category
Mode
Table 1: Menu Categories and Options (Software Version 1.2 and later)
Options Next Level
Manual
(Manual
Setting
mode, local
control only
(no DMX)
Address
DMX-8B
(Unit is set to LastHold
operate in
DMX512 8-
Bit mode)
State
Address
DMX-16B
(Unit is set to LastHold
operate in
DMX512 16-
Bit mode)
State
Dimmer
Factory
CCT
Preset (01 - 09)
Dimmer (0 - 100%)
Custom
WW (Warm White) 0-
100% CW (Cool
White) 0-100%
MANUAL ADDENDUM
Meaning
Rotate wheel to set
dimmer level from 0 to
100% (in 1% increments)
Rotate wheel to set CCT
level from 3000K to 6000K
(in 1K increments)
Allows users to set and
adjust Presets, Dimmer,
and WW / CW (CCT) to
their specific requirements.
Sets the units DMX512
address (from 001 to 512)
Sets the units operation
should DMX512 signal be
disconnected or lost - YES
(maintain last DMX512
state) or NO (do not
maintain last DMX512
state)
Information only - displays
if DMX512 is present
(connected) or not
Sets the units DMX512
address (from 001 to 512)
Sets the units operation
should DMX512 signal be
disconnected or lost - YES
(maintain last DMX512
state) or NO (do not
maintain last DMX512
state)
Information only - displays
if DMX512 is present
(connected) or not
1
85-6384