Comcast Visonic MCT-340 SMA Battery Installation
Comcast Visonic MCT-340 SMA Battery Installation

Comcast Visonic MCT-340 SMA Battery Installation

Door / window sensor

Advertisement

Quick Links

Door / Window Sensor Battery Installation –
Visonic MCT-340 SMA
What You'll Need
Visonic MCT-340 SMA Door / Window Sensor
One CR2032 battery
Double-sided tape (optional)

How to Install the Battery

Before proceeding, please be sure that your system is disarmed. Working on devices while the system is armed can
generate false alarms.
Did You Know? You may want to have some double-sided tape on hand if you need to remove your Sensor from the
wall to install a battery. Cut the tape to size and reattach your Sensor if the existing adhesive fails to hold it in place.
Is This Your Sensor? Make sure that your
Sensor looks like the one in the image. If it
does, you have the right document to find out
how to install a battery in your Sensor.
Did You See? There is a mark located on
the side of the Sensor (see arrow above) that
shows the recommended side to use when
matching up the Sensor with the magnet.
The same mark is found on the magnet for
easy alignment.
1. Locate the small horizontal raised lines in
the shape of a pyramid on the Sensor.
2. Place your thumb or finger on the
horizontal lines and push/pull towards the
end of the Sensor. The cover will slide
down a short distance, allowing you to pull
the cover off the Sensor.
Take a Look. If a battery is already present,
remove it by using your fingertip to gently pull
one end of the battery up until the battery is
loose and you can pull it free from the slot.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Visonic MCT-340 SMA and is the answer not in the manual?

Questions and answers

Summary of Contents for Comcast Visonic MCT-340 SMA

  • Page 1 Door / Window Sensor Battery Installation – Visonic MCT-340 SMA What You’ll Need • Visonic MCT-340 SMA Door / Window Sensor • One CR2032 battery • Double-sided tape (optional) How to Install the Battery Before proceeding, please be sure that your system is disarmed. Working on devices while the system is armed can generate false alarms.
  • Page 2 3. Insert the CR2032 battery by placing it flat against the prongs in the battery compartment with the negative (-) side facing down. The battery should fit inside the battery cradle. 4. Align the small tabs on the cover with the slots in the track on the Sensor's body and press the cover down onto the Sensor.

Table of Contents