Advertisement
Quick Links
Before use, refer to User's Instructions, P/N 03521015, for detailed System instructions and information.
NOTE: Four Helmet Mounting Snaps (arrows
at right) attach the Helmet Liner to the Helmet.
1. Position the Liner near the Helmet inside (A).
The Liner Cord Slot (red arrow) allows the
Liner to install with the Power Cord attached
to the Helmet. Place the Liner between the
Power Cord and the Helmet.
A
3. Secure one front Liner Snap to the Helmet Snap by pressing the Liner Snap firmly to the Helmet Snap. A click
occurs when the snap is secured. Repeat for the other front Liner Snap. Repeat for each rear Liner Snap (B2).
Top Left
2. Secure the Liner to the Helmet.
Begin by securing the Liner front edge under and
against the front lip of the Helmet (B1, red arrow). The
Liner front should be "caught" in this recessed area at
the Helmet front.
B2
Top Right
1 of 2
Helmet Liner
Part #: 2071-01
NIOSH Ref #: 03531021
B1
Bottom Left
Bottom Right
P/N 03531021 REV B
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Maxair CAPR 2071-01
- Page 1 Helmet Liner Part #: 2071-01 NIOSH Ref #: 03531021 Before use, refer to User’s Instructions, P/N 03521015, for detailed System instructions and information. NOTE: Four Helmet Mounting Snaps (arrows at right) attach the Helmet Liner to the Helmet. 1. Position the Liner near the Helmet inside (A). The Liner Cord Slot (red arrow) allows the Liner to install with the Power Cord attached to the Helmet.
- Page 2 Helmet Liner Part #: 2071-01 NIOSH Ref #: 03531021 4. Secure the Helmet Liner rear (C1) to the Helmet rear (C2) by pressing them together. A slight snap occurs when the Liner is secure to the Helmet (C, press/squeeze in direction of red arrows). 5.
Need help?
Do you have a question about the CAPR 2071-01 and is the answer not in the manual?
Questions and answers