Advertisement
8. Using a soldering iron, connect the grey and blue twisted pair to
the amplifier terminals as follows:
grey, Bassmon blue to amplifier brown.
Installation is now complete with the 1
the new Bassmon volume control.
Check all connections for proper hookup.
Reinstall all covers removed during the installation.
Turn on the organ in the normal manner.
Play and hold Low C on the lower manual, a match pack can be used
to wedge the key down.
Adjust the "DB Level" trim pot to taste.
with the regular organ tones, but not so loud as to cause
distortion or undue vibrations in the tone cabinet.
Release the Low C and play in a staccato fashion
You should be hearing a 32', 8', and string bass tone that goes
all the way to low F on the keyboard.
"Octave" and "Pluck" trimmers are not turned down to "0".
You will now adjust that "Pluck" tone to your liking by adjusting
the "pluck" trim pot on the Bassmon.
You will now hold Low C again, and adjust the "Octave" trim pot
to produce the desired mixture of 8' tone.
IMPORTANT:
The Bassmon is a monophonic synthesizer, which means it
can only play one note at a time.
optimized for BASS, so it should only be played in the
bottom 3 octaves of the keyboard.
Attempting to play chords, other harmonies, or notes in
the upper 2 octaves of the manual can yield
unpredictable (and unmusical) results.
st
FINAL CHECK AND ADJUSTMENT
Page 2 of 2
Bassmon grey to amplifier
lower manual drawbar acting as
It should be balanced
If not, check that the
Further it is
050327
Advertisement
