Caribbean Controls M Series Quick Start Manual

Bassmon Manual String Bass M Series Edition
FOR USE WITH:
1 – BASSMON CHASSIS
4 – MOUNTING SCREWS
This kit contains
installed to a Hammond M Series spinet, it provides 32', 8' pedal and
string bass tones on the lower manual, adjustable via onboard trim
pots.
NOTE ABOUT 32' PITCH:
player can access 16' Low C on the lowest C note of the lower manual.
If standard 16' tones were provided it would be like having pedals that
stopped at low F.
of the lower manual play low F thru low B at a 32' pitch; lower then
ANY Hammond console, with the exception of the RT series pedal solo
unit!
CAUTION:
CAUTION:
DISCONNECT ALL EQUIPTMENT FROM POWER BEFORE PROCEEDING.
1. Install the Bassmon chassis to the right of the amplifier.
2. Remove the Brown wire from the rear of the 1
drawbar, and remove the Red wire from the 2
drawbar.
3. Connect the orange wire from the Bassmon to the Brown wire
disconnected in step 2.
4. Connect the grey wire from the Bassmon to the red wire
disconnected in step 2.
5. Connect the black wire from the Bassmon to a chassis screw on the
amplifier chassis.
6. Using a soldering iron, connect the purple wire from the Bassmon
st
to the 1 lower manual drawbar.
7. Locate the AC mains terminals on the amplifier by removing the
left most cover plate.
with grey, blue, and brown wires attached.
M, M2, M3, and M100 spinets.
KIT CONTENTS
INTRODUCTION
the Bassmon String
This lower pitch was selected so that the spinet
Very inconvenient!
Due to the presence of electrical
potential, only an experienced
technician should perform
installation procedures or
adjustments involving 110vac or
220vac "mains" power.
INSTALLATION
There you should see three terminals,
Page 1 of 2
2 – WIRE NUTS
INSTALLATION INSTRUCTIONS
Bass Unit.
As a result, the 7 lowest keys
st
lower manual
nd
lower manual
When properly
050327