Electrical Connection; Start-Up Of The Cabinet - Delta ERD12 User Manual

The cabinet operates on 230 V/50 Hz. The wall socket should be easily accessible.
All earthing requirements stipulated by the local electricity authorities must be
observed. The cabinet plug and wall socket should then give correct earthing. If in
doubt, contact your local supplier or authorized electrician.
The flexible cord fitted to this appliance has three cores for use with a 3-pin 13-
Amp or 3-pin 15- Amp plug. If a B.S. 1363 (13-Amp) fused plug is used, it should
Electrical connecting
be fitted with a 13-Amp fuse.
The wires in this mains lead are coloured in accordance with the following code:
The cabinet operates on 230 V/50 Hz.
Green/Yellow: Earth, Blue: Neutral, Brown: Live.
The wall socket should be easily accessible.
The main electrical connections must be done by skilled electricians.
All earthing requirements stipulated by the local electricity authorities must be observe
cabinet plug and wall socket should then give correct earthing. If in doubt, contact your
supplier or authorized electrician.
Before use, we recommend that the cabinet is cleaned, (see the section on
maintenance and cleaning).
The flexible cord fitted to this appliance has three cores for use with a 3-pin 13-Amp or
Amp plug. If a B.S. 1363 (13-Amp) fused plug is used, it should be fitted with a 13-Am
The wires in this mains lead are coloured in accordance with the following code:
If the cabinet has been vertically placed during transport, please wait 2 hours
Green/Yellow: Earth, Blue: Neutral, Brown: Live.
before starting up the cabinet. Connect the cabinet to a socket and turn on
The main electrical connections must be done by skilled electricians.

Start-up of the cabinet

Before use, we recommend that the cabinet is cleaned, see the section on maintenance a
Important !
If the cabinet has been vertically placed during transport, please wait 2 hours before sta
cabinet.
Connect the cabinet to a socket and turn on the switch on the control panel, see fig. 1.9
Connect the cabinet to a socket and
turn on the switch on the control
panel, see fig. 1.3.
4
Electrical connecting
Start-up of the cabinet
Important!
the switch on the control panel, see fig. 1.2.
Fig. 1.2
Fig. 1.9
Fig. 1.3