assembly and usage Warnings contents Components list Assembling footrest Attaching legs Attaching/removing tray table Inserting/removing tray insert Low chair mode Securing your child contacts Product registration Customer service These instructions detail the safe use, assembly and maintenance of your product. Please read these instructions carefully and ensure that they are followed at all times.
WARNINGS TO AVOID INJURY OR DEATH HIGHCHAIR MODE: FOLLOW THE MANUFACTURER’S INSTRUCTIONS. DO NOT LEAVE CHILDREN UNATTENDED. THE HARNESS MUST ALWAYS BE USED AND CORRECTLY FITTED. MOST INJURIES FROM HIGHCHAIRS ARE CAUSED BY FALLS. POSITION THE HIGHCHAIR AWAY FROM SOLID STRUCTURES AND BENCHES TO AVOID INJURIES CAUSED BY FALLS AND BY ACCESS TO DANGEROUS ITEMS.
Page 4
WARNINGS BOOSTER SEAT MODE: PREVENT SERIOUS INJURY OR DEATH FROM SLIDING OUT, FALLS, OR TIPPING OVER. • ALWAYS secure child in the restraint until child is able to get in and out of the booster seat without help (about 2 1/2 years old). The tray is not designed to hold the child in the booster.
Seat x 1 Tray table x 1 Tray insert x 1 Lower legs x 4 Upper legs x 4 Footrest bar x 1 WARNINGS TO AVOID INJURY OR DEATH: In highchair and low chair mode: Please ensure the booster seat straps are securely stored underneath in the seat...
Step 1: assembling footrest 1. Push in the pop pin of the upper leg located on the top of the bar. upper leg lower leg 2. Slide the leg through the Footrest bar. Repeat for the second upper leg.
Step 2: attaching legs • Insert four (4) Upper Legs into the bottom of the Highchair Seat in the corresponding holes, ensuring the locking pins on each leg are secured in place.
• Insert the Tray Table into the slots (Figure A) and push down gently until the tray clicks into place and is level with the seat. (Figure B) • Place the tray insert into place and push down gently.
• The insert tray snaps onto the tray table and is held into place by the tab at the rear of the insert. Tray table with insert fitted removing tray insert •...
This seat can be used as a lowchair by simply removing the four (4) lower legs. The footrest is optional in lowchair mode.
Page 11
WARNINGS • ALWAYS use both sets of chair straps to completely secure booster to the chair. • If chair is cushioned and cushion cannot be removed, BE CERTAIN that the bottom chair strap is fastened snugly after putting child in seat.
Page 12
• The straps for the booster seat function are located underneath the seat in two storage areas. When the booster seat mode is not in use, the straps MUST be securely stored in the storage areas 1 & 2 as shown.
Page 13
• Place the booster seat on a sturdy dining chair. Pass the bottom chair straps underneath the chair and fasten securely. • Ensure the strap is tightened underneath the chair securely using the adjustment straps (figure.D).
Page 14
• Ensure you tighten chair strap for security. • To securely store the booster seat straps in the storage areas, squeeze the small plastic clip and open one storage area. Ensure all straps fit snugly inside the secured compartment storage areas.
Page 15
• Ensure the compartment clicks into place when closed to ensure straps are locked away securely (figure.E).
• The harness strap can be adjusted by moving each strap’s slider. • The buckle is released by squeezing the buckle tongues together. WARNING Use this harness at all times. A five-point harness is provided to secure your child.
Page 17
mother’s choice tip... follow us on motherschoice.com.au Visit us online to register your new Mother’s Choice product. www.motherschoice.com.au/product-registration to prevent loss or fading, please attach your receipt here:...
Need help?
Do you have a question about the Egg and is the answer not in the manual?
Questions and answers