Campbell Juniper System Allegro DOS Quick Start Manual

Before you begin using your Allegro DOS
Complete all of the steps outlined in each section of this guide.
A
LLEGRO
Q
UICK
Installing the battery pack into the Allegro Installing the battery pack into the Allegro
Before turning on the Allegro, the battery pack must be installed. To do
this, complete the following steps:
1) Push up on the release latches on the
sides of the Allegro to open the battery
compartment door.
2) Place the NiMH battery pack in the left side
of the battery compartment, push down,
and slide it to the right.
3) Push the battery door closed until each
release latch clicks into place.
4) Slide the release latches downward until
they cannot slide any further to securely
latch the battery door closed.
Do not turn on the Allegro yet.
5) Plug the AC wall charger that came with
the Allegro into the wall socket.
Note: A small green light on the wall adapter
turns on when it is plugged into the wall.
6) Remove the rubber protector from the
Allegro's external power input jack.
7) Plug the power connector end of the AC
wall charger into the Allegro. The Allegro
turns on automatically.
The MS-DOS operating system loads onto
the Allegro, a progress bar appears. No
action is required until the New Battery
Detected screen appears.
DOS
S G
TART UIDE