Medisana APS Manual page 20

GB
4 Miscellaneous
4.2
Disposal
14
• Ensure the plastic casing of the electric discharge wire is in the correct
position.
Plastic casing
Cleaning and replacing the filter
• The filter is able to collect large amounts of dust. Use a soft brush to
clean it. Replace the filter when is it heavily soiled and unable to be cleaned
properly. This should be after one year of use at the latest.
Replacing the UV lamp
• The efficiency of the UV lamp declines over time. Depending on how often it
is used, the UV lamp
the device and disconnect the plug from the mains socket. Make sure the
device is completely disconnected from the power supply. Remove the UV
lamp carefully from the holder.
• Insert a new UV lamp into the UV holder. Make sure it is in the correct
position.
Assembling the device
1. When all the parts are clean and dry, the device can be assembled. Proceed
in the reverse order as in "Removing the filter".
2. Underneath the electrostatic dust collector
Make sure they are in the correct position. Otherwise the device cannot be
supplied with power.
3. The device has two safety notches
ly latched in. Otherwise the device cannot be supplied with power.
This product must not be disposed together with the domestic waste.
All users are obliged to hand in all electrical or electronic devices, regardless
of whether or not they contain toxic substances, at a municipal or commer-
cial collection point so that they can be disposed of in an environmentally
acceptable manner.
Consult your municipal authority or your dealer for information about disposal.
needs to be replaced roughly once a year. Switch off
. Make sure the front cover is proper-
there are metal electrodes.