Page 1
1 Attach tall legs IRIS’ four tall legs allow for a safe landing with the gimbal. Attach the two black legs to IRIS’ black arms and the two blue legs to IRIS’ blue arms. Turn IRIS upside down, and set the leg into the notches on the bottom of the arm.
Your Tarot gimbal is compatible with a GoPro HERO3, available from store.3dr.com. Important note: Make sure that the WiFi on your GoPro is turned OFF at all times when in use with IRIS. Remove the two screws securing the blue face plate.
Page 3
Add face plate. 3 Connect Follow these instructions to connect the gimbal to IRIS. This will allow you to control the tilt of the camera in flight using your RC transmitter. To enable automatic camera stabilization without RC control, skip to the step 3: power.
Page 4
4 Power Connect the gimbal power cable with the red, JST connector to the matching cable protruding from the bottom of IRIS. If you do not see the cable, please see the advanced gimbal instructions at 3dr.com/iris/info. 5 Attach the gimbal to IRIS Use the two mounting screws to attach the gimbal to IRIS using the two holes in the interface plate and the two holes in the bottom shell shown below.