Tv Menu; Install; Select The Menu Language; Store Tv Channels - Philips 37PFL7422/93 User Manual

TV menu-Install
Main Controls

Install

5
Language
Auto store
Manual store
Channel setting
Factory reset
Info
Main Controls
Install 5
Language
Auto store
Manual store
Channel setting
Factory reset
Info
Auto store
Please wait
Prog. found
Frequency 246.50
Notes:
• Immediately after unpacking and plugging in your new television, run the auto store function to set up the TV for the broadcast or
cable channels available in your area. If you do not run the auto store function to set up the channels, your television may not
operate properly.
• After you've run Auto store, check out the results. Press P (+) or the P (-) button and see which channels you can select.
• Remember, an antenna or cable TV signal must first be connected to your LCD TV.
Language 2
English
中文
Auto store
Start ?
0
MHz

Select the menu language

Press the MENU button on the remote control.
Use the cursor down to select Install in the Settings menu.
2
Use the cursor right to enter the Install menu.
3
Select Language and enter the list of available languages with the
4
cursor right.
Select your preferred language with the cursor up/down and press
5
the OK button to confirm your selection.
6
Proceed with the Install menu.

Store TV channels

Press the MENU button on the remote control.
2 Use the cursor down to select Install in the Settings menu.
Use the cursor right to enter the Install menu.
3
Press cursor down to select Auto store in the Install menu.
4
Use the cursor right to enter the Auto store menu and press OK
5
to start scanning of channels.
Auto storing may take up to 3 minutes to complete. Please wait
until Auto storing is completed . The TV will then switch
automatically to the first channel found.
10