Philips 52PFL5604H/12 User Manual page 43

Your TV supports Philips EasyLink, which
uses the HDMI CEC (Consumer Electronics
Control) protocol. EasyLink-compliant devices
that are connected through HDMI connectors
can be controlled by a single remote control.
•
Philips does not guarantee 100%
interoperability with all HDMI CEC devices.
•
The EasyLink-compliant device must be
switched on and selected as the source.
When you connect your TV to devices that
support one-touch play, you can control your
TV and the devices with one remote control.
When you connect your TV to devices that
support standby, you can use your TV remote
control to put your TV and all connected
HDMI devices in standby mode.
When you connect your TV to HDMI
CEC compliant devices, your TV can
switch automatically to play audio from the
connected device.
To use one-touch audio, you must map the
audio input from the connected device to
your TV.
You can use the remote control from the
connected device to adjust the volume.
RC key forwarding allows you to control
EasyLink-compliant devices using your TV
remote control.
42
You can control EasyLink-compliant devices
with the following buttons on the remote
control of your TV.
( Starts, pauses or resumes
) playback on your EasyLink
device.
( ) Stops playback on your
EasyLink device.
( ) Starts or stops video recording
on your EasyLink device.
Searches backward on your
( ) EasyLink device.
( ) Searches forward on your
EasyLink device.
When EasyLink is enabled,
( selects a title, chapter or track.
)
Navigates through the menus
( of your EasyLink devices.
)
Activates a selection or
accesses the menu of your
EasyLink device.
Displays the menus of your
EasyLink device. Note that
when
TV menu is displayed.
Switches back to the antenna
source from EasyLink mode.
( When EasyLink is enabled,
) switches the TV and all
EasyLink devices to standby.
Press and hold
for at least 3 seconds.
( ) is pressed, the
( )