Advertisement
Quick Links
© 2016 Edge Lighting. All Rights Reserved.
Installation Instructions for Controller Dial with Power Supply
IMPORTANT INFORMATION
- This instruction shows a typical installation.
SAVE THESE INSTRUCTIONS!
Installing CDP Panel
A
2
CONTROLLER
POWER
SUPPLY
DEEP SINGLE
GANG BOX
3: Loosen the six Phillips screws on front of the power supply to
remove the cover.
4: Carefully pull off the cover from the DVR-RGB-60 driver.
www.edgelighting.com
info@edgelighting.com
1
120 NEUTRAL
120 HOT
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
NOTE:
Before beginning any electrical work, ensure that power
to the electrical box is turned off.
NOTE:
This product requires deep double gang electrical box.
1: Connect the brown and blue wires of the 24VDC transformer
to the 120 volt hot and neutral wires with wire
nuts respectively.
2: Place the controller power supply inside the double gang
box.
WALL
B
3
COVER
COVER
CDP
PHILLIPS SCREW
M
M
904-CDP_02
POWER SUPPLY
CASE
DVR-RGB-60
4
1
Advertisement
Summary of Contents for Edge Lighting CDP
- Page 1 1718 W. Fullerton Ave Chicago, IL 60614 Tel: 773-770-1195 Fax: 773-935-5613 www.edgelighting.com info@edgelighting.com © 2016 Edge Lighting. All Rights Reserved. Installation Instructions for Controller Dial with Power Supply IMPORTANT INFORMATION - This instruction shows a typical installation. SAVE THESE INSTRUCTIONS! Installing CDP Panel...
- Page 2 NOTE: Refer to the "Configuring DimWheel" & "Operating CONTROLLER DimWheel" for help on programming the Dimwheel. CONTROLLER 5: Connect the red wire of the power supply to the "VDC+" POWER SUPPLY terminal of the controller. 6: Connect the black wire of the power supply to the "Ground" terminal of the controller.
- Page 3 14: Screw CDP unit onto gang box using provided screws. NOTE: Reference operation guide for information on programming CDP unit. GANG BOX WALL...
Need help?
Do you have a question about the CDP and is the answer not in the manual?
Questions and answers