Summary of Contents for Playcore Spectrum Aquatics Summit WP 400
- Page 1 Summit WP 400 Part Number 42440 7100 Spectrum Lane ~ Missoula MT 59808 800.791.8056 ~ www.spectrumproducts.com 42440 Man Rev A...
-
Page 2: Shipping Information
® You have purchased a Spectrum Products Swim Lift Summit WP 400. Providing the unit is installed correctly and properly maintained, it will furnish you with many years of trouble free use. It is important to read this entire manual prior to beginning assembly or operation. Shipping Information: Each lift should arrive fully assembled on a single pallet. -
Page 3: Components And Hardware
Components and Hardware 800.791.8056 ▪ www.spectrumproducts.com... -
Page 4: Installation Overview
Installation Overview Read all instructions before attempting to assemble or install the Lift. Anchor Location It is recommended that the Summit be installed in or near the shallow end of the pool with sufficient deck space and operational area in the pool as shown in Figure 1. For reasons of safety and ADA guidelines, the lift must be installed in a location that is clear from obstacles and other hazards. - Page 5 3. Set the expansion anchor at the bottom of the anchor hole by tapping the anchor pin with the supplied ¼” diameter set tool rod with a hammer. 4. Locate a bonding source to bond (ground) the anchor. The steel rebar-bonding grid of the pool deck is the best choice for bonding the anchor.
-
Page 6: Lift Operation
Lift Operation Read all operating instructions before operating the lift. Make sure that all WARNING! individuals using the lift have read the instructions and have been made aware of all safety precautions. Do not exceed the maximum lifting capacity of 400 lbs (181.4 kg). This may result in WARNING! damage to the lift or personal injury. - Page 7 inexperienced users, we recommend that an attendant always be present. Instruct all operators on the proper use of the chair features and the transfer procedure. 3. A lock pin is attached to the top of the cylinder to lock the chair in the fully raised position or rotated 180°...
-
Page 8: Care And Maintenance
Care and Maintenance The following should be performed periodically to ensure safe and dependable use. 1. Remove any discoloration with a 3M scratch pad (stainless steel components only). Wipe clean with a sponge dampened with Spectra Clean. Repeat these steps several times to passivate the stainless steel. -
Page 9: Troubleshooting
Troubleshooting Problem: Cause: Solution: 1. Lift will not operate at all: Unit Not Level Check for level and shim accordingly Valve Failure Replace Valve (P/N 27285, Kinked Hose 27286) Air in Cylinder Un kink hose and recheck Dirty Cylinder Run unit 5-7 times up and down while assisting motion Worn Top Collar Call for assistance...
Need help?
Do you have a question about the Spectrum Aquatics Summit WP 400 and is the answer not in the manual?
Questions and answers