Related Manuals for Xyron Wishblade
Summary of Contents for Xyron Wishblade
-
Page 1: Getting Started
Xyron Wishblade Getting Started Guide Provided By http://www.MyBinding.com http://www.MyBindingBlog.com... - Page 2 Wishblade and plug the thinner rectangular (computer) end into an open USB port on your computer. NOTE: DO NOT plug into a USB hub, the Wishblade must be directly plugged into the computer, for the software to recognize the port.
- Page 3 To cut paper or any media you must either place it on the Cutting paper/ media on cutting mat Mat or it must have Xyron Adhesive Backing on it. You can run the Liner paper or media through a Xyron 9” Creative Station™ to place the Adhesive backing to it.
- Page 4 Software After you have set up your Wishblade, it is time to install the software. Simply insert your CD into your computer and the setup program will automatically launch. Follow the onscreen instructions to install the software on your computer. If you are installing more than one software package, Xyron Wishblade Software and Xyron Create and Cut Software, they are on separate CD’s and...
Need help?
Do you have a question about the Wishblade and is the answer not in the manual?
Questions and answers