Next Harper Highsleeper Assembly Instructions Manual

IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
Tools Needed
Helpline
If you have any problems with this
product or require any replacement
fittings please contact Customer
Services Tel: 0844 844 8999
Regrettably self assembly items cannot be returned once assembly is part or fully completed
unless the item is found to be faulty. Should you need to return the unassembled product,
please repack in the original packaging.
IMPORTANT
• We suggest you spend a short time reading through this leaflet and then follow the simple
instructions.
• Carefully check that you have all parts before beginning assembly.
• Keep fittings out of children's reach and keep children well away from the construction area.
• We recommend that the packaging is used to protect the surfaces during assembly.
• A minimum of 2 persons is required to assemble this product.
• We recommend the use of the wall attachment bracket for safety reasons.
PRODUCT INFORMATION
Made in Poland.
CARE INSTRUCTIONS
• For general cleaning, periodically dust with a soft cloth.
• Do not rub or scrub the surface when cleaning.
• Always use a non-silicone based furniture polish. Silicone in furniture polishes can break down the lacquer finish.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
Avoid keeping furniturein direct sunlight or closeto any heat sources as this can cause cracking,
discolouration or warping.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
All assembly fixings should always be tightened properly and periodically check all fixings and tighten if necessary.
• The finish will mellow and change colour over time.
SAFETY INFORMATION
(BS EN 747-1:2007)
Recommended mattress size 1900mm x 900mm x 120mm
Follow the manufacturer's assembly instructions in detail to ensure the safety
features of the bed are not compromised.
Warnings:
To ensure the safety, regularly check all the connecting bolts and glide pins making sure they are tight,
care should be taken that no screws are loose.
To prevent falls, the maximum mattress thickness should not exceed 185mm
The high beds and the upper beds of bunk beds are not suitable for children
under six years due to the risk of injury from falls.
Maximum mattress thickness is permanently marked on the inner side of upper bed.
The bunk bed and the high bed should not be used if any structural part is broken or missing.
Children can strangle in items such as robes, strings, cords, harnesses and belts
attached to or hung on a bunk bed or high bed.
Children can become trapped between the bed and the wall. To avoid risk of serious
injury the distance between the top safety barrier and the wall shall not exceed 75mm or shall be more than 230mm.
852973 HARPER HIGHSLEEPER
ASSEMBLY INSTRUCTIONS.
1 of 24
step by step
P5--HA80